Servis-Rhino RC-12 Point Hitch, Drawbar-Pull Type Mower, Front End Weight, Power Take Off PTO

Page 48

OPERATION

OPERATION

2.3Tractor Horsepower

The horsepower required to operate the mower depends on many factors including the vegetation to be cut, terrain condition, operator experience, and condition of the mower and tractor. For most mowing condition, the RC12 requires a tractor with at least 90 HP. Operating the mower with a tractor that does have adequate power may damage the tractor engine.

2.4 3-Point Hitch

Lift Type RC Flails should be coupled with a quick hitch only. Direct coupling to tractor 3 point will result in driveline failure. Sufficient weights should be added to front of tractor to maintain steerage weight on front tires when flail is raised (20% of tractor weight should be on front tires). Never stand between flail and tractor when coupling with quick hitch. Remove or adjust drawbar to provide clearance for driveline on lift type units. Adjust top link so machine does not tilt back when raised, increasing angles of u-joints which may cause premature failure.

2.5 Drawbar-Pull Type Mower

For equipment operating at 540 RPM, the tractor drawbar must be positioned at a 14” distance from the hitch point to the PTO shaft end for proper operation and minimal wear to the driveline. OPS-R- 0061_D

2.6 Front End Weight

Maintain a minimum of 20% total tractor weight on the tractor front end at all times. Front end weight is critical to maintain steering ability and to prevent the front end from rearing up. Consult your authorized tractor dealer for front weights and carriers.

2.7 Power Take Off (PTO)

Only operate the mower on a tractor equipped to operate at 540 rpm PTO speed. Tractors operating at 540 rpm will have a 1-3/8” diameter 6-spline PTO shaft stub. Refer to the tractor operator’s manual for operating the PTO at the proper speed.

RC12 12/05

Operation Section 4-6

© 2005 Alamo Group Inc.

Image 48
Contents RC-12 Warranty Information To the Owner/Operator/DealerTable of Contents Maintenance Section Safety Section Safety Wait a minute...Save a life Safety Equipment Operation Safety Instructions and Practices Stop Mowing if Passersby are Within 100 Yards Unless Safety Safety RC12 Safety Section STI-3 Safety MPH. STI-6 Maintenance and Service Safety Instructions and Practices Parts Information Concluding Safety Instructions and Practices Peligro ReflectInstruct NFS SER PLT LogoName ModelDecal Description Has stopped. P/N RC12 Safety Section Safety Safety Safety Safety Safety Safety Federal Laws and Regulations Introduction Section Introduction Before Operating this Machine Owners Responsibilities Safety Instructions Page Assembly Section Breather Plug Installation Tongue Assembly InstallationShipping Stand Removal Assembly Asm-FL-0066 Point Hitch Assembly Installation Attaching Axle Assemblies to Main Wheel BAR Tube Attaching Optional Hydraulic CylinderOperation Section Operation Operation CAT II-III Q.HOperator Requirements Personal Protective Equipment PPETractor Safety Devices Tractor Requirements and CapabilitiesRops and Seat Belt Front End Weight Power Take Off PTO3-Point Hitch Drawbar-Pull Type MowerGetting on and OFF the Tractor Boarding the TractorDismounting the Tractor Connecting the Mower to the Tractor Starting the TractorSetting the Mower Pull Type ModelsLift Type Models Semi-Mount ModelsOperation Driveline Attachment Leveling DeckDriveline Clearance PRE-OPERATION Inspection and Service Engagement Check ProcedureShorten the driveline profiles as follows Tractor Pre-Operation Inspection/Service Mower Pre-Operation Inspection/ServiceSGM-10 Operation Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock Setting Raising the MowerTurning Procedure Driving the Tractor and MowerCrossing Ditches and Steep Inclines Operating the Tractor and Implement Operation Bystanders/Passersby Precautions Foreign Debris HazardsEngaging the Power Take Off PTO PTO RPM and Ground Speed Operating the MowerOperation Shutting Down the Implement Disconnecting the Mower from the Tractor OPS-F-0012AMower Storage Transporting the Tractor and ImplementOperation Transporting on Public Roadways OPS-U Hauling the Tractor and Implement Trouble Shooting Guide Problem Possible Cause RemedyPTO RPM Page Maintenance Section General Maintenance LubricationRoutine Maintenance Blade Replacement Belt Adjustment and ReplacementCutter Shaft Pulley Alignment and Removal Maintenance Installation Cutter Shaft and Bearing RemovalCutter Shaft Bearing Removal Mnt-FL-0041 Outer Cutter Shaft Bearing RemovalTOP Drive Assembly Servicing Cutter Shaft RemovalDriveline Shield Replacement DrivelineMnt-FL-0032 Figure Mnt-FL-0036 Storing the RC12 Pre-season CheckRhino Required of the Owner Required of the OperatorRC12 12/05 00726339C Printed U.S.A