Servis-Rhino RC-12 manual Asm-FL-0066

Page 40

ASSEMBLY

ASSEMBLY

•Place key (item 1) in end of jackshaft and slide round end of PTO shaft over jackshaft. Attach with two 3/8" set screws (item 2). Align set screws with dimples in jack shaft. Apply thread locking compound to threads

to prevent loosening. Ensure driveline and jackshaft U-joint are in phase.

Asm-FL-0066.

•Place jack shaft shield (item 1) in place over shield mount (item 2) and bearing stand. Fasten in place with two 3/8" bolts, lockwashers and washers at shield mount and on either side of bearing mount. Asm-FL- 0067.

RC12 12-05

Assembly Section 3-4

© 2005 Alamo Group Inc.

Image 40

Contents RC-12 Warranty Information To the Owner/Operator/DealerTable of Contents Maintenance Section Safety Section Safety Wait a minute...Save a life Safety Equipment Operation Safety Instructions and Practices Stop Mowing if Passersby are Within 100 Yards Unless Safety Safety RC12 Safety Section STI-3 Safety MPH. STI-6 Maintenance and Service Safety Instructions and Practices Parts Information Concluding Safety Instructions and Practices Reflect PeligroInstruct NFS SER PLT LogoName ModelDecal Description Has stopped. P/N RC12 Safety Section Safety Safety Safety Safety Safety Safety Federal Laws and Regulations Introduction Section Introduction Before Operating this Machine Owners Responsibilities Safety Instructions Page Assembly Section Tongue Assembly Installation Breather Plug InstallationShipping Stand Removal Assembly Asm-FL-0066 Point Hitch Assembly Installation Attaching Axle Assemblies to Main Wheel BAR Tube Attaching Optional Hydraulic CylinderOperation Section Operation Operation CAT II-III Q.HOperator Requirements Personal Protective Equipment PPETractor Requirements and Capabilities Tractor Safety DevicesRops and Seat Belt Front End Weight Power Take Off PTO3-Point Hitch Drawbar-Pull Type MowerGetting on and OFF the Tractor Boarding the TractorDismounting the Tractor Connecting the Mower to the Tractor Starting the TractorSetting the Mower Pull Type ModelsLift Type Models Semi-Mount ModelsOperation Driveline Attachment Leveling DeckDriveline Clearance Engagement Check Procedure PRE-OPERATION Inspection and ServiceShorten the driveline profiles as follows Tractor Pre-Operation Inspection/Service Mower Pre-Operation Inspection/ServiceSGM-10 Operation Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock Setting Raising the MowerTurning Procedure Driving the Tractor and MowerCrossing Ditches and Steep Inclines Operating the Tractor and Implement Operation Bystanders/Passersby Precautions Foreign Debris HazardsEngaging the Power Take Off PTO PTO RPM and Ground Speed Operating the MowerOperation Shutting Down the Implement Disconnecting the Mower from the Tractor OPS-F-0012AMower Storage Transporting the Tractor and ImplementOperation Transporting on Public Roadways OPS-U Hauling the Tractor and Implement Trouble Shooting Guide Problem Possible Cause RemedyPTO RPM Page Maintenance Section General Maintenance LubricationRoutine Maintenance Belt Adjustment and Replacement Blade ReplacementCutter Shaft Pulley Alignment and Removal Maintenance Installation Cutter Shaft and Bearing RemovalCutter Shaft Bearing Removal Mnt-FL-0041 Outer Cutter Shaft Bearing RemovalTOP Drive Assembly Servicing Cutter Shaft RemovalDriveline Driveline Shield ReplacementMnt-FL-0032 Figure Mnt-FL-0036 Storing the RC12 Pre-season CheckRhino Required of the Owner Required of the OperatorRC12 12/05 00726339C Printed U.S.A