Hitachi SJ-PB(T) Malfunction codes, Fault code SJ300/L300P Fault description Parameter

Page 24

CHAPTER5 OPERATING

The malfunction codes are coded as follows.

	Table5- 2 Malfunction codes
Fault code SJ300/L300P		Fault description
parameter 947
0		No fault
1		Overcurrent inverter.
2		Overcurrent deceleration.
3		Overcurrent acceleration.
4		Overcurrent.
5		Overload protection.
6		Braking resistor overload protection.
7		Over-voltage protection.
8		EEPROM error.
9		Under-voltage.
10		Current detector error.
11		CPU error.
12		External trip.
13		USP error.
14		Ground fault protection.
15		Incoming over-voltage protection.
16		Temporary power loss protection.
21		Abnormal temperature.
23		Gate allay error.
24		Open-phase error.
30		IGBT error.
35		Thermistor error.
36		Abnormal brake.
60-69		Option 1 error 0-9.
70-79		Option 2 error 0-9.

20

Image 24

Contents Hitachi Inverter Revision History Table Safty Precautions Otherwise, there is a danger of connecting error Otherwise, there is a danger of electric shock and/or fireOtherwise, there is a danger of electric shock Otherwise, there is a danger of fireInspection Upon Unpacking Outline of product Appearance and Names of PartsTechnical features of Profibus-DP Profibus-DP Supported VersionProduction specification Application temperature 0 to 50 degreeInstallation of option board Mounting method of option boardProfibus connectors Physical interfacePin Layout of SJ-PB Name Function Pin Layout of SJ-PBTWiring note PROFIBUS-DPProfibus Configuration Node AddressBaudrate PPO-type selectionSetting of controlling frequency and start/stop commands Action at communication errorP001/P002 Action at error detection Remarks PPO- description OperatingPKW-part PCA wordRequest Function Ackn + Response ID FunctionPZD-part Control- / status word STW/ZSWStatus word Profidrive state diagram Frequency set-point/ Actual frequencyPZD word Please NoteParameter Examples Writing a four byte parameterWriting a two byte array parameter Writing a two byte array parameter #2 Profidrive specific parameters Profidrive parametersFault code SJ300/L300P Fault description Parameter Malfunction codesTrip display Protection function listCountermeasure for a trip state LED display and CountermeasureCode Size Range Magn Contents L300P Read Parameter cross-reference listCode Size Range Magn H033 ～655.35A 100 1st No load current Io of motor Auto B023 126 10～30.00 100 Constant value of Overload restriction C111 169 ～200.0% Level2 of overload restriction warning A053 215 ～5.0s Delay time of DC braking start B045 252 00,01 Code Selection of LAD stop by torque Appendix P013 329 00～03 Code Selection of method of Pulse lines input Code Size