KODAK 1200i
NOTE: It is suggested to assemble the right stand leg first, then attach the assembly to the printer. Repeat with left stand leg assembly. Do not ‘completely’ tighten the screws between stand legs and platen – only perform after the crossbar has been installed.
Step 3: Crossbar Installation
-Install crossbar between stand legs and tighten four (4) securing screws.
-Tighten the eight (8) stand leg screws after the crossbar has been properly installed.
Step 4: Auto Clean Unit System (2 electrical connections/1 tubing connection)
-To attach the auto clean unit first connect the ink tube line to the pump nipple. Attach both electrical plug connections to respective jacks. Angle the assembly at a 45 degree angle to connect over the 4 securing screws. Tighten four (4) securing screws.
-Verify the disposal bottle is installed and tubing connections to bottle are intact.
Technical Training Guide | 10 |