KODAK 1200i
Printer Installation (Quick Steps)
Step 1: Shipping Brackets Removal
-Rotate printer head box 90 degrees onto one side and remove printer from large shipping box by pulling out and away from box.
-Before removing the shipping support brackets ensure the printer is properly placed and balanced
on two or three strips of packing foam provided.
-Remove the two (2) bolts
securing the metal crossbeam between the support brackets.
-Remove upper and lower shipping support brackets (four bolts total) and install appropriate stand leg to balance the printer. Remove wing nut, retaining bolt, and 4 screws.
Step 2: Media System Installation (1 electrical connection)
-When installing the right stand leg attach electrical plug connection to printer base; ensure the plug is aligned straight and square onto the connector to prevent damage to the electrical pins. CAUTION: plug pins
are extremely fragile; ensure restraining clips are secure.
-‘Loosely’ attach the eight (8) stand leg
screws to the printer base; this will allow for proper installation of the stand’s crossbar.
CAUTION:
Avoid pushing
plug into the
platen assembly.
Technical Training Guide | 9 |