Kodak 1200I manual Waiting for Cartridge Access, Carriage Fpga Error, PEN Error, Bottle Error

KODAK 1200i WIDE-FORMAT PRINTING SYSTEM

WAITING FOR CARTRIDGE ACCESS...

Reminder: A print job is ready but the system is waiting for the user to give up control of the carriage. The user should press ‘Access Cartridge’ to return the carriage and to enable printing to begin.

This error may easily occur following routine cleaning where cartridges were accessed or if the operator decides to activate a ‘Cut’ following an ‘Access Cartridge’ and the operator forgets to return carriage to home position.

WARNING: ADJUST REAR PAPER GUIDES

Friendly Reminder: Each time the paper is loaded this message is presented to the user. The user should inspect the paper path and press ‘Ok’ to clear this warning. The front paper guides should be verified as well.

NOTE: Always ensure the rear media edge guides are spaced at least 1-2 mm away from the media edges following a media load; the media should not

be in contact with the guide or media drag may occur and possibly cause left or right side banding. Refer to Technical Bulletin 1 for complete media load instructions.

CARRIAGE FPGA ERROR

Error: Normally this message indicates the carriage trailing cable or board is unplugged. There is no method of clearing this error the printer must be power cycled.

PEN ERROR!

This error message is provided to clarify a retained “Pen Error – Job Paused!” error status after a job is “Reset” by the user and is no longer paused. Refer to pages 1-8 above.

BOTTLE ERROR!

This error message is provided to clarify a retained “Bottle Error – Job Paused!” error status after a job is “Reset” by the user and is no longer paused. Refer to pages 9-12 above.

Technical Training Guide 59