Kodak 1200I manual Kodak 1200i WIDE-FORMAT Printing System

KODAK 1200i WIDE-FORMAT PRINTING SYSTEM

4.Electrostatic discharges from media or personnel can cause data interference, typically the data will be observed shifting away from the edge of print or image may appear to have an ink overspray problem. Contact technical support for suggestions to overcome these symptoms (refer to Technical Bulletin 10). A Carriage Axis Error may result if interference with image signals is too severe or if incoming power is too low (i.e. less than 100 volts AC).

NOTE: These symptoms are different from No. 2 above.

5.If a CAE occurs and ink is observed around the service station area (ink is spitting up through the service station and onto the carriage assembly) at right side of printer the auto clean unit may be defective. Contact technical support.

NOTE: The encoder strip, encoder sensor and carriage paper sensor should be cleaned or errors may continue to occur. To clean the encoder strip/sensor refer to Technical Bulletin 3. To clean the paper sensor remove power and the service station, gently blot the paper sensor (located directly behind the magenta stall position flex driver cable approximately 5-7 mm). Refer to Routine Maintenance.

Technical Training Guide 56