KODAK 1200i WIDE-FORMAT PRINTING SYSTEM
2. The ‘Perfect’ Media Load
-After loading media in the normal routine, it is best to perform a ‘perfect media load’. Hold the feed roller guide (round plastic guide) at
right side with one hand and then simultaneously press the Feed Media - Forward button. Drive media forward until it pulls against the media roll, keep holding (do not allow guide to rotate) for another 10 seconds or so - resistance is the key to pull the media straight.
NOTE: the media guides should be pulled all the way out when loading media (see Caution
above). Also, once the media is tight, driving media ‘forward’ aids in alignment.
3. Dryer Modes
To activate the drying system, select Setup Menu - Dryer Menu. Scroll through available selections. 12 dryer modes are available; refer to dryer matrix label affixed to printer’s top cover or Installation Step #14 above for specific modes of operation.
0 = OFF
1 = Fans Only
2 = Minimum, Fans On
3 = Minimum
4 = Heat Low, Fans On
5 = Heat Low
6 = Heat Medium, Fans On
7 = Heat Medium
8 = Heat High, Fans On
9 = Heat High
10 = Maximum, Fans On
11 = Maximum
NOTE 1: The air plenum may be lowered to the maintenance position by removing 2 locking pins and gently lowering plenum. The air plenum should be only be lowered when performing printer calibrations and replacing cartridges.
NOTE 2: The air plenum may also be completely removed for certain media print applications (i.e. 50” bond media) where the media becomes obstructed by the air plenum. Contact technical support for assistance with removal.
Technical Training Guide | 28 |