Load up to
10 envelopes
25 sheets of labels
50 transparencies
Make sure
•The print side of the envelopes faces you.
•The stamp location is in the upper left corner.
•The envelopes are designed for use with inkjet printers.
•The envelopes are loaded in the center of the paper support.
•The paper guides rest against the edges of the envelopes.
Warning: Do not use envelopes that have metal clasps, string ties, or metal folding bars.
Notes:
–Do not load envelopes with holes, perforations, cutouts, or deep embossing.
–Do not use envelopes that have exposed flap adhesive.
–Envelopes require more drying time. Remove each envelope as it exits, and allow it to dry to avoid ink smudging.
1
2
•The print side of the labels faces you.
•The top of the labels feeds into the printer first.
•The adhesive on the labels does not extend to within 1 mm of the edge of the label.
•You use full label sheets. Partial sheets (with areas exposed by missing labels) may cause labels to peel off during printing, resulting in a paper jam.
•The labels are loaded in the center of the paper support.
•The paper guides rest against the edges of the labels.
Note: Labels require more drying time. Remove each sheet of labels as it exits, and allow it to dry to avoid ink smudging.
•The rough side of the transparencies faces you.
•If the transparencies have a removable strip, each strip faces away from you and down toward the printer.
•The transparencies are loaded in the center of the paper support.
•The paper guides rest against the edges of the transparencies.
Notes:
•Transparencies with paper backing sheets are not recommended.
•Transparencies require more drying time. Remove each transparency as it exits, and allow it to dry to avoid ink smudging.
35