Xerox 2060 Configure the printer in PSF/MVS, Table F-5. PSF/MVS Printdev statement parameters

Defining the printer to the host: TCP/IP attachment

4. Configure the printer in PSF/MVS

Follow these steps to configure the printer in PSF:

1.Locate the PSF startup procedure in the JES3 or JES2 startup JCL procedure. This is normally kept in SYS1.PROCLIB, although your system may use a different library.

The libraries specified by the //PROC00 DD statement normally contains startup procedures for PSF subsystems. The name of the procedure is specified in the initialization dataset (FSS statement PROC parameter in JES2; the FSSDEF statement PNAME parameter in JES3. See the appropriate section in this appendix for clarification).

2.Add a PRINTDEV statement to define the printer in PSF. (See the example below for the general format or the Print Services Facility for OS/390 Customization for more information.)

The table below contains descriptions of the PSF parameters which need to be set for the printer.

Table F-5. PSF/MVS PRINTDEV statement parameters

			Range of
Item		Source of	acceptable		Your
description	Default	value	values	Comments	value
APPLID	None	VTAM APPL	1 to 8-character	Not applicable for TCP/
		statement	alphanumeric	IP-attached printer
			string
BUFNO		N/A	5 to 100	Not applicable for TCP/
				IP-attached printer
FAILURE		Installation	WCONNECT or	If printer is used by other
		preferences	STOP	hosts, WCONNECT
				causes PSF to
				continuously retry to
				establish connection with
				printer.
FDEFDD	None	Installation	1 to 8-character	Name of the form
		preferences	alphanumeric	definition library DD
			string	statement
FONTDD	None	Installation	1 to 8-character	Name of font library DD
		preferences	alphanumeric	statement. Fonts in this
			string	library must match
				resolution the printer is
				using.

Installation Planning Guide F-9