Xerox 2060 manual Table F-1. JES2 FSS statement parameters, Proc, Autostop

Defining the printer to the host: TCP/IP attachment

Configuring in JES2

3. Configure the PSF printer in JES2 or JES3

This section discusses the procedures for configuring the printer in JES2 or JES3 environments.

To configure the PSF printer in JES2, follow these steps:

1.Locate the JES2 initialization dataset in the JES2 Startup JCL Procedure (JES2 PROC). (This is normally kept in SYS1.PROCLIB, although your system may use a different library.)

The JES2 PROC has a DD statement (normally HASPPARM), which points to the initialization dataset. (The location of this statement is SYS1.PARMLIB(JES2PARM); however, you should always verify the location on your own system.)

2.Enter the following required commands in the JES2 initialization dataset to define the PSF functional subsystem (FSS):

•One FSS statement for each PSF functional subsystem

•One PRTnnnn statement for each functional subsystem application (FSA) under control of the FSS. (This can also be specified as PRINTnn or PRINTERn.)

The following table lists the JES2 FSS statement parameters to be defined.

Table F-1. JES2 FSS statement parameters

			Range of
Item		Source of	acceptable		Your
description	Default	value	values	Comments	value
FSS parameters
PROC	None	PSF Startup	1 to 8-character	Specifies name of
		procedure	alphanumeric	procedure for starting
		name/	string	this FSS. Different
				FSS statements can
				refer to the same
				startup procedure
AUTOSTOP	NO	Installation	YES or NO	Specifies whether FSS
		preferences		address space is
				stopped automatically
				if all FSAs under
				control of the FSS are
				stopped.

Installation Planning Guide F-3