Xerox 2060 manual Configuring in JES3, Table F-2.JES2 Initialization Dataset commands example

Defining the printer to the host: TCP/IP attachment

Table F-1. JES2 FSS statement parameters (Continued)

			Range of
Item		Source of	acceptable		Your
description	Default	value	values	Comments	value
ROUTECDE	None	Installation	1 to 4	If WS if F, only output
		printer name	destination	with these destinations
		standards	names	is selected for this
				printer.
START	YES	Should be NO	YES or NO	START=NO should be
		for TCP/IP		specified so TCP/IP
		printers.		can be started before
				the FSS.
TRKCELL	no	See JES2	YES or NO	IBM recommends
		SPOOLDEF		YES.
		statement
WS	None	Installation	See JES2	Consider CL, R, and F.
		preferences	Initialization	See JES2 Initialization
			and Tuning	and Tuning Manual for
			Manual.	more information.

Following is an example of the JES2 Initialization Dataset required commands:

Table F-2.JES2 Initialization Dataset commands example

FSS (FSS1) PROC=FSSPROC1,HASPFSSM=HASPFSSM,AUTOSTOP=YES

PRT0001CLASS=E,FSS=FSS1,MODE=FSS,PRESELCT=YES,

START=NO,TRKCELL=YES,WS=(Q)

Configuring in JES3

Follow these steps to configure the PSF printer in JES3:

1.Locate the JES3 initialization dataset (commonly known as Initialization Deck) in the JES3 catalogued JCL Procedure. (This is normally kept in SYS1.PROCLIB, although your system may use a different library.)

The JES3 PROC has a JES3IN DD statement, which points to the initialization dataset. The default initialization deck is in SYS1.SAMPLIB (member JES3IN00); however, you should verify your location by looking at the JES3 procedure.

2.Enter the following required commands in the JES3 initialization deck to define the PSF functional subsystem (FSS):

•One FSSDEF statement for each PSF functional subsystem

Installation Planning Guide F-5