|
| 6: Line and Tunnel Settings |
|
|
|
| Tunnel Connect Mode | Description |
| Settings (continued) |
|
| Block Serial | Set whether Block Serial is enabled for debugging purposes. Choices are: |
|
| Enabled = If Enabled, incoming characters from the Serial Line will not be |
|
| forwarded to the network. Instead, they will be buffered and will |
|
| eventually flow off the Serial Line if hardware or software flow control is |
|
| configured. |
|
| Disabled = this is the default setting; incoming characters from the Serial |
|
| Line are sent on into the network. Any buffered characters are sent first. |
|
|
|
| Block Network | Set whether Block Network is enabled for debugging purposes. Choices are: |
|
| Enabled = If Enabled, incoming characters from the network will not be |
|
| forwarded to the Serial Line. Instead, they will be buffered and will |
|
| eventually flow off the network side. |
|
| Disabled = this is the default setting; incoming characters from the |
|
| network are sent on into the Serial Line. Any buffered characters are sent |
|
| first. |
|
|
|
| Email on Connect | Select an email profile number to which an email notification will be sent |
|
| upon the establishment of an accept mode tunnel. |
|
|
|
| Email on Disconnect | Select an email profile number to which an email notification will be sent |
|
| upon the disconnection of an accept mode tunnel. |
|
|
|
To Configure Tunnel Connect Mode Settings
Using Web Manager
To configure the Connect Mode for a specific tunnel, click Tunnel in the menu and select Tunnel 1
Using the CLI
To enter the Tunnel 1 Connect Mode command level: enable
Using XML
Include in your file: <configgroup name="tunnel connect" instance="1">
Disconnect Mode
Specifies the optional conditions for disconnecting any Accept Mode or Connect Mode connection that may be established. If any of these conditions are selected but do not occur and the network disconnects to the device, a Connect Mode connection will attempt to reconnect. However, if none of these conditions are selected, a closure from the network is taken as a disconnect.
| Table | |
|
|
|
Tunnel Disconnect |
| Description |
Mode Settings |
|
|
Stop Character |
| Enter the Stop Character which when received on the Serial Line, disconnects |
|
| the tunnel. The Stop Character may be designated as a single printable |
|
| character or as a control character. Control characters may be input in any of |
|
| the following forms: <control>J or 0xA(hexadercimal) or \10 (decimal). |
|
| Disable the Stop Character by blanking the field to set it to <None>. |
|
|
|
| 42 |
