Star Micronics FR-15, FR-10 manual Cu t, T p O b u o t @ k c, N . D T u E

G		H	C
O a P		c	r	u		M	y c Cu t
~	a (	k	o t c		t	t o	a p	o a
t s	T p		a g	s	y w h		t r t p
G	.	S	y M	m		f f	d
C	e	o t	o	t t s		t t p	c b t	o
o a o b u o t			(			@ k c
S		T	P		F	T	D
P

TP command can be used to transmit control codes and escape sequences 120ma file to the printer in order to setup various parameters. For instance, if you want to set up NLQ printing, the command is <ESG x 1 (lBh 78h 31h).

A file must therefore be created using these tie charactem. Though the MS-DOS line editor EDLIN can be used, there is a small difficulty in inputting the <ESO character. This is achieved with the following se- quence:

mm

and then the ASCII “xl” can be input. The file is then saved, and output to

t p T s c t b s l t f

A E N . D

N F

I*

O c		i y h	a t e		o w	w	a	y t
i	c	s	a t <		c	t i p	p	t
u	E	F f d		o h t u E		c	y o
s		m

8