Xantrex Technology PV100S-480 installation manual Layout Options, 1PV100S Layout Option a

Planning

Layout Options

The PV100S is shipped as two separate assemblies and can be arranged as shown in Figure 2-1 or Figure 2-2.

The PV100S can be arranged in a number of different system layout options to fit specific site requirements. The AC interface/transformer assembly may be co-located adjacent to the left side of (or behind) the Main Inverter Enclosure up to, and not exceeding, 15 feet away.

Given the flexibility to co-locate the AC interface/transformer assembly to fit a desired system layout, the interconnect AC power conductors and conduit between the Main Inverter Enclosure and the AC interface/transformer assembly are to be supplied by the installer. See Figure 2-1 and Figure 2-2, depicting two options for locating the AC interface/transformer assembly adjacent to the main inverter.

Minimum Dimension of Base:

Approximately 12 ft. by 6 ft. (3.6 m x 1.8 m)

12' (3.6 m)

6'

(1.8 m)

36"

Minimum

Clearance

			BASE: Concrete Floor or Pad
		Communications
	12"
				Approximately 12 ft by 6 ft
		Enclosure
Minimum
Clearance				(3.6 m x 1.8 m)

					6" Minimum Clearance
AC	Transformer				DC Interface	12"
Interface					Enclosure	Minimum
Enclosure	Enclosure					Clearance
		Conduit
		12"			36"
				Inverter	Minimum
		Minimum
			36"	Enclosure	Clearance
	36"	Clearance*
		from Inverter)	Minimum
		(15' Max. Distance
	Minimum		Clearance
	Clearance

Figure 2-1PV100S Layout Option A

2–6 152315 Rev C