PC Communications
Establishing a POTS Connection
Important: A direct analog phone line to the local phone service is required to use this feature. The phone line used for PV100S communication cannot be routed through a Private Branch Exchange (PBX) unless an analog PBX card is used.
To connect a personal computer using the POTS Connection:
1.Ensure the personal computer to be used has a 56K modem installed.
2.Open the Communications Enclosure.
3.Plug the local phone line into the RJ11 port on the SA2 Surge Arrestor marked "UNPROTECTED".
SA2 Surge Arrestor
MultiTech 56K
Modem
Figure 3-20 Telephone Cable Routing
4.Install the GUI Software following the instructions in the PV100S 100 kW
5.Use a Terminal Emulation program on the PC to access the modem.
See the GUI Help Menu "Communication by Modem" for instructions on setting up the Terminal Emulation program on the computer. See also, "Connect to Telephone Number" and "Connect to Remote Inverter by Modem" for additional information.
6.Use the GUI to setup the connection information.
a)From the GUI Main page, click on <TOOLS>
b)Click on the inverter icon for the inverter to be setup.
c)Click on the <INVERTER DATA>
d)Click on the <CONNECTION> tab.
e)Fill out the information required on the <GENERAL> page, the
<TELEPHONE FAULT CONFIGURATION> page, and the <TELEPHONE CONFIGURATION> page.
152315 Rev C |