Xantrex Technology ENET-XFR Auxb?, Cmode?, Dly?, Err?, Fold?, Hold?, Id?, Imax?, Iout?, Iset?

Command Summary

Table 3-4Query Commands

AUXA?Command	DescriptionAsks for the state of the set value for the AUXA command
AUXB?	Asks for the state of the set value for the AUXB command
CMODE?	Asks for the power supply’s calibration mode status.
DLY?	Asks for the programmable time delay setting before the supply
	reports fault conditions.
ERR?	Asks for the most recent remote programming error which
	occurred in the supply since the last time the error query
	command (ERR?) was used.
FOLD?	Asks for the supply’s present foldback setting.
HOLD?	Asks for the present hold mode setting.
ID?	Asks for the power supply’s model name and master EPROM
	version.
IMAX?	Asks for the supply’s soft current limit setting.
IOUT?	Measures the supply’s actual current output.
ISET?	Asks for the supply’s present output current limit setting.
OUT?	Asks for the present enabled/disabled status of the supply’s
	output.
OVSET?	Asks for the supply’s present over voltage protection limit.
REN?	Asks for the state of remote enable.
ROM?	Asks for the version number of the master and slave EPROMs on
	the interface PCB.
VMAX?	Asks for the supply’s soft voltage limit setting.
VOUT?	Measures the supply’s actual voltage output.
VSET?	Asks for the supply’s present output voltage setting.

TM-XR9B-01XN 3–7