Xantrex Technology ENET-XFR3 manual PossibleCauses

Operation

Table 3-10 Ethernet Mode Tips

SymptomAble connect to the device server

(Ethernet Bridge), but unable to control r receive a response from the power supply

PossibleCauses	Corrective Actions
The Eth rnet/RS-232	Reconfigure the interface card for Ethernet
Interface card is configured	c	mmun cations. See page 2–12for details.
for RS-232 communications
The embedded Ethernet	Ensure that the baud rate for the Ethernet Bridge
Bridge is incorr ctly	is set for 9600 by connecting to its HTTP server
c nfigur d	and checking its Serial Port settings. This can be
	d	ne by entering the device's IP address into a
	web brows r and using the correct username and
	password to ac ess the device server. See
	“Configuring Ether et Bridge” on page 2–15 for
	m	information.
	Ensure hat the baud rate setting on the interface
	card is set to 9600 - ee the “Baud Rate
	Selection” on page 2–18 for details.

3–22 TM-XR9B-01XN