Xantrex Technology ENET-XFR manual Error0 #ErrorNo ErrorsIdentificationExplanation, Error Codes

Error Codes

Error Codes

If the ERR flag in the accumulated status or fault registers has been activated, an ERR? query will return an error number which corresponds to an event described in the following table. The ERR? query will also clear the ERR bit in the register.

Table 3-9Error Codes

Error0 #ErrorNo ErrorsIdentificationExplanation

4	Unrecognized Character	Received	character such as @,*,$.
	Improper Number	Received	numeric character but the
		characters were not a proper number.
		Example: VSET,±10.3
	Unrecognized String	Received	invalid command.
	Syntax Error	Received	incorrectly placed word,
		number, separator, or terminator.
		Example: OFF SRQ, VOUT 6, MASK,
		ERR
5	Number Out of Range	Specified	value for the command which
		was outside of the allowed range.
6	Attempt to Exceed Soft	Attempted to program a voltage or
	Limits	current greater than the soft limit.
		Example: VMAX 500; VSET 550 LF
7	Improper Soft Limit	Attempted to program a soft limit less
		than the output value.
8	Data Requested without a	The controller requested data from the
	Query Being Sent	power supply without first sending a
		query command.
9	OVP Set Below Output	Sent an OVSET command with a trip
		value lower than the output voltage.
10	Slave Processor Not	The interface PCB slave processor did
	Responding	not respond.
12	Illegal Calibration	Attempted calibration when the supply
		was not in calibration mode. See
		CMODE command.

TM-XR9B-01XN 3–19