Chapter 3 Installing Components
Installing Components Using the CLI
Installing the Device Provisioning Engine
To install the DPE:
Step 1 When the installation program prompts you to select one or more components, press y and Enter at Device Provisioning Engine (y/n/?).
To skip installing an RDU and Network Registrar extension points, enter n and Enter for these options.
For example:
Installation Components
Select one or more components to install BPR.
Regional distribution unit (RDU) (y/n/?) [no] n
Cisco Network Registrar extension points (y/n/?) [no] n
Device Provisioning Engine (DPE) (y/n/?) [yes] y
Key Distribution Center (KDC) (y/n/?) [no] n
The program prompts you to confirm the components that you want to install.
Step 2 Press y and Enter to continue. The program displays a message that it is starting individual component validation. Press Enter to continue
Step 3 When validation is complete, the program prompts you to enter the home directory destination. Validation involves checking to verify that the correct patches have been installed. If they are not, error messages appear on screen.
Step 4 To accept the default home directory destination, /opt/CSCObpr/, press Enter, or enter another directory. For example:
Home Directory Destination
Home Directory Destination [/opt/CSCObpr]
Choosing yes will create the directory during the installation. Choosing no will allow a different directory to be chosen.
The directory /opt/CSCObpr does not exist. Create it? (y/n/?) [yes]
Step 5 When validation is complete, the program prompts you to enter the data directory destination.
Step 6 To accept the default data directory destination, /var/CSCObpr/, press Enter, or enter another directory. For example:
Data Directory Destination
Data Directory Destination [/var/CSCObpr]
Choosing yes will create the directory during the installation. Choosing no will allow a different directory to be chosen.
The directory /var/CSCObpr does not exist. Create it? (y/n/?) [yes]
The program prompts you to confirm the components that you want to install.
Step 7 Press y and Enter to create the directory and continue. The program displays the installation parameters that you selected. For example:
Installation Parameters
This screen shows the installation parameters that you have chosen:
| Cisco Broadband Access Center for Cable Installation Guide 2.7 |
|