Cisco Systems Broadband Access Center manual Debugging, Controls Available

Chapter 7 Setting Up a Device Provisioning Engine

Debugging

Controls Available

These commands described in this section, provide additional configuration settings. Changing these properties on the DPE-590 causes the change to take effect immediately, without a DPE restart. If you are working with a lab install, and modify any DPE property, you must restart the DPE for the change to take effect.

•packetcable registration encryption—This command optionally enables encryption of the MTA configuration file.

Tip dpe.properties: /pktcbl/regsvr/configEncrypt=1

•no packetcable registration encryption—This command optionally disables encryption of the MTA configuration file.

Tip dpe.properties: /pktcbl/regsvr/configEncrypt=0

•packetcable snmp timeout <timeout>—This command dynamically sets the number of seconds that the DPE waits for a response to an SNMPv3 SET operation. The timeout is expressed in seconds and the default value is 10 seconds.

Tip dpe.properties: /pktcbl/snmp/timeout=1 and /pktcbl/snmp/timeout=10

Debugging

Complete these steps to verify that your DPEs are operating properly after configuring them for operation with voice technology.

Step 1 Enter this command to collect all the log, property, and network configuration files on the DPE :

support bundle state

This command places the collected log files in the /outgoing directory. From there, the bundle is accessible using FTP.

Step 2 Enter this command to check the status of both the DPE and voice technology settings:

show dpe

Example show dpe command output

BPR Agent is running dpe is running

Version BPR 2.5 (cbpr_25_L_200302040515).

Caching 51970 device	configs and 2 external files.
Received 312 cache hits and		0 misses.
Received 0 lease updates.
Connection status is	Disconnected.
Sent 77 SNMP informs	and 77	SNMP sets.
Received 77 MTA provisioning successful SNMP informs.
		Cisco Broadband Access Center for Cable Installation Guide 2.7
OL-19105-01			7-7