Extron electronic MLC 52 manual Projector remote control type a application

Projector remote control type A (application 1)

This remote control has a discrete button for each input. Two buttons are designated for RGB inputs, one for S-video, and one for video (composite).

•Use IR learning to program the command from each of the projector remote control RGB input selection buttons onto the MLC PC button.

•Use IR learning to program the commands from the projector remote control Video and S-video buttons onto the MLC Video or blank (VC models) button.

(See Configuring Using IR Learning on page 18 for the IR learning procedure.)

The MLC now has two commands each on the PC and Video or blank (VC models) buttons. This enables you to switch between the two PC inputs by repeatedly pressing the PC button, and between the two composite/S-video inputs by repeatedly pressing the Video or blank button.

Standard MLC 52 models with a type A remote control

If you are using a standard (non-VC) MLC 52 IR or an MLC 52 RS with a type A remote control, program the buttons using the following scheme:

				INPUTS
VIDEO	S-Video	RGB1		RGB2
SET				POWER
UP		PRG+
		PLAY	UP
	TIME/		TIME/
	LEVEL– DLY/CNT/REAR		LEVEL+

REW PAUSE FF

LEFTRIGHT

STOP DOWN

PRG–

–SKIP/CHAPTER +

TV	DIR A	DECK	DIR B
		A/B
INPUT
		+100
EFFECT	REC/	SLEEP	TV
	PAUSE
ON/OFF			MUTE

INPUT SELECT

CD TAPE TUNER

1 2 3

PHONO DVD/LD VCR

4 5 6

TV/DBS

7 8 9

ENT 0 DISP

TEST

	DISPLAY
ON	OFF
VOL	PC
VOL	VIDEO
	MLC 52

Command 1: RGB 1

Command 2: RGB 2

Command 1: Video

Command 2: S-Video

Projector Remote Type A

Figure 31. Programming MLC 52 Input Selection Buttons from a Projector Remote Control Type A

MLC 52 MediaLink Controllers • Special Applications 35