Extron electronic MLC 52 manual Projector Remote Type a

				INPUTS
VIDEO	S-Video	RGB1		RGB2
SET				POWER
UP		PRG+
		PLAY	UP
	TIME/		TIME/
	LEVEL– DLY/CNT/REAR		LEVEL+
	REW	PAUSE	FF
	LEFT		RIGHT

STOP DOWN

PRG–

–SKIP/CHAPTER +

TV	DIR A	DECK	DIR
		A/B		B
INPUT
		+100
EFFECT	REC/	SLEEP	TV
	PAUSE
ON/OFF			MUTE

INPUT SELECT

CD TAPE TUNER

1 2 3

PHONO DVD/LD VCR

4 5 6

TV/DBS

7 8 9

ENT 0 DISP

TEST

		DISPLAY
VOLUME	ON	OFF
Command 1: Video 1 IR Command“A”	VCR	PC
Command 2: Video 1 IR Command“B”
Command 1: S-video 2 IR Command“A”	DVD
Command 2: S-video 2 IR Command“B”
		MLC 52

Command 1: RGB 1 IR Command“A”

Command 2: RGB 1 IR Command“B”

Optional:

Command 1: RGB 2 IR Command“A”

Command 2: RGB 2 IR Command“B” Label the button button accordingly and place it in input switch mode.

Projector Remote Type A
Figure 38. Programming an MLC 52 VC with a Projector Remote Control Type A
1. Place the rear panel configuration DIP switch 1 in the On (up) position to	ON
enter learning mode. (If the MLC is already in learning mode, proceed to
step 2.)	1	2	3 4

2.Using IR learning, program command “A” from the Video input selection button on the projector remote control into memory block 1 of the Video or blank button (for VC models) as follows:

a.Press the Video button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the bottom IR learning LED flashes.

b.Within 5 seconds (while the Video button on the MLC 52 is blinking), press the Video or blank button on the projector remote control. The MLC has learned command “A” for video.

3.Program the input selection command “A” from the S-video input selection button on the projector remote control into memory block 2 of the MLC 52 Video or blank button as follows:

a.Press the Video or blank button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the second LED from the bottom flashes.

b.Within 5 seconds (while the Video or blank button on the MLC 52 is blinking), press the S-video button on the projector remote control. The MLC learns command “A” for S-video.

4.Program the input selection command “B” from the Video selection button on the projector remote control into memory block 3 of the MLC 52 Video or blank button as follows:

a.Press the Video or blank button on the MLC front panel. The button blinks, indicating that the MLC is ready to learn the command. On the rear panel, the third LED from the bottom flashes.

b.Within 5 seconds (while the Video or blank button on the MLC 52 is blinking), press the Video button on the projector remote control. The MLC learns command “B” for video.

MLC 52 MediaLink Controllers • Special Applications 41