Extron electronic MLC 52 manual Projector remote control type B application

MLC 52 VC models with a type A remote control

If you are using an MLC 52 IR VC or an MLC 52 RS VC model with a type A remote control, program the buttons using the following scheme:

				INPUTS
VIDEO	S-Video	RGB1		RGB2
SET				POWER
UP		PRG+
		PLAY	UP
	TIME/		TIME/
	LEVEL– DLY/CNT/REAR		LEVEL+

REW PAUSE FF

LEFTRIGHT

STOP DOWN

PRG–

–SKIP/CHAPTER +

TV	DIR A	DECK	DIR B
INPUT		A/B
		+100
EFFECT	REC/	SLEEP	TV
	PAUSE
ON/OFF			MUTE

INPUT SELECT

CD TAPE TUNER

1 2 3

PHONO DVD/LD VCR

4 5 6

TV/DBS

7 8 9

ENT 0 DISP

TEST

		DISPLAY
VOLUME	ON	OFF
Command 1: Video IR	VCR	PC
command
Command 1: S-video	DVD
IR command
		MLC 52

Command 1: RGB 1 IR command

(If applicable) Command 1: RGB 2 IR command. The button also must be placed in the input switch mode and labeled appropriately.

Projector RemoteType A

Figure 32. Programming MLC 52 IR VC and MLC 52 RS VC Input Selection Buttons from a Projector Remote Control Type A

Projector remote control type B (application 1)

This remote control has only two input buttons — one for the RGB inputs and one for the S-video and composite video inputs. Each of these buttons contains one command that causes the projector to toggle between inputs.

•Program the command from the Computer or RGB button of the projector remote control onto the PC button of the MLC.

•Program the command that is on the Video button of the projector remote control onto the Video button of the MLC.

The MLC now has one command each on its PC and Video buttons. You must still repeatedly press an input button to switch between selected sources; however, the button actually contains only one command (a projector input toggle command).

MLC 52 MediaLink Controllers • Special Applications 36