Extron electronic manual Setting the Internet Protocol IP Address, IPL T S4

Lighting

Control

RS-232

Extron

IPL T S4

		COM	3	Ethernet Control
COM	1	COM	2	Interface

22

09301205COM

UID#	LAN
POWER	RS-232

TCP/IP

NetworkRS-232

Ethernet

Remote User

Control and

Administrator

Monitoring

Laptop DVD

Extron

MAV 62

Matrix Switcher

on Extr

Extron

MediaLinkor

Other Controller

Projector

VCR

Figure 3-2 — Typical IPL T S interface operating configuration

2.	Connect the other end of the serial cable to the display or switching device to
	be controlled through the IPL T S.

Setting the Internet Protocol (IP) Address

The IPL T S Series units have a factory default IP address of 192.168.254.254. This IP address must be changed to an address that will operate on your local network.

There are three ways to change the IP address setting:

•Add Device > Auto Config IP option in Global Configurator

•IPL T S unit’s embedded Web pages

•Address Resolution Protocol (ARP) command

Before you begin:

1.	Obtain a valid IP address for your IPL T S Series device from your A/V
	system’s network administrator.
2.	Write down the unit’s MAC address (a 12-digit number) found on a label on
	the rear panel of the unit (for example, 00-05-A6-01-0A-74).
3.	If the unit is not at it’s factory default IP address (192.168.254.254), perform a
	Mode 4 reset:
	a.	Hold down the Reset button until the Power LED blinks twice
		(6 seconds), then release.
	b.	Press and release the Reset button again within 1 second.
		The Power LED blinks quickly four times, confirming the Mode 4 reset,
		which returns the unit to its factory default IP address.

IPL T S Series • Connection and Configuration 3-3