Installation and Operation, cont’d
IPLT
S2
R 1TX 2
COM |
| |
RX | RTS | CTS |
®
100 LINK ACT
IPLT
S2
R 1TX 2
COM |
| |
RX | RTS | CTS |
®
100 LINK ACT
D MD |
| |
ISTR | AS |
|
| IBU ER | |
| TION | IES |
| AMPL | |
|
| IFIER |
Figure 2-2 — Mounting the interface on the standard shelf
Furniture or projector mounting
The following furniture and projector mount kits are available:
• | PN | Furniture mount kit (for IPL T S1) |
• | PN | Projector mount kit (for IPL T S1) |
• | PN | Furniture mount kit (for IPL T S2, S4, S6) |
• | PN | Projector mount kit (for IPL T S2, S4, S6) |
To mount an IPL T S Series device to furniture:
1. | If present, remove the rubber feet from the bottom of the IPL T S unit. |
2. | Attach the furniture mounting brackets to the unit with the supplied screws. |
3. | Hold the unit with the attached brackets against the underside of the |
| furniture. Mark the hole locations of the bracket on the mounting surface. |
4.Drill
5. | Insert #8 wood screws into the four pilot holes. Tighten each screw until just |
| less than 1/4 inches (6.3 mm) of the screw head protrudes above the surface. |
6. | Hang the mounting bracket over the protruding screw heads. Slide the |
| mounting brackets to the narrow end of the screw slots and tighten the |
| mounting screws. |
To mount an IPL T S Series device with a projector:
1. | If present, remove the rubber feet from the bottom of the IPL T S unit. |
2. | Attach the projector mounting bracket to the unit with the supplied screws. |
3. | Secure the unit to the projector post with the supplied mounting bolt. |