Extron electronic IPL T S manual Setting the IP address using the ARP command

	Figure 3-6 — Web server System Settings screen
To return the local PC to its original TCP/IP settings:
1.	Close the Web browser.
2.	Disconnect the Ethernet crossover cable from the PC and the device.
3.	Return to the TCP/IP Properties dialog box on the PC.
4.	Return the IP address, Subnet mask, Default gateway, and DHCP fields to
	their original settings.
5.	Reboot the PC.

Setting the IP address using the ARP command

An IPL T S unit’s IP address can be set using the DOS Address Resolution Protocol (ARP) command.

The IPL T S unit must be:

•physically connected to the network

•at its factory default IP address

To set an IP address using the ARP command:

1.	Open a command prompt window on a local PC. On Windows XP, a
	command prompt window can be found at:
	Start > All Programs > Accessories > Command Prompt
2.	At the command prompt type:
	arp - s<IP address><MAC address>

example: C:\>arp -s 10.13.197.64 00-05-A6-00-30-5F

The example command assigns IP address 10.13.197.64 to the device that has a MAC address of 00-05-A6-00-30-5F.

IPL T S Series • Connection and Configuration 3-7