Extron electronic ISM 482 manual Front Panel Security Lockout Executive Mode

Page 32

3.Rotate the Adjust knob or Adjust knob to vary the settings within the following adjustment ranges:

NOTE: The Adjust knobs have no mechanical limits to their rotation.

•Color/Tint: Color adjusts within a range of 0 to 127. Tint adjusts within a range of 0 to 255.

•Brightness/Contrast: The range for both adjustments is 0 to 63.

•Size: Observe the display and turn the Adjust knob to increase or decrease the horizontal size of the image. Turn the Adjust knob to increase or decrease the vertical size of the image. The adjustment range depends on the input rate applied and the selected output resolution.

•Center: Observe the display and turn the Adjust knob to center the image horizontally or the Adjust knob to center the image vertically. The adjustment range depends on the input rate applied and the selected output resolution.

•Horizontal and vertical filter (RGB or component video input): Horizontal (Horz) adjusts within a range of 0 to 3.

Vertical (Vert) adjusts within a range of 0 to 7.

•Filter (S-video and composite video input): Either knob adjusts within a range of 0 to 7.

4.Repeat steps 2 and 3 for each image adjustment to be made for that output.

5.If you want to set picture adjustment on the another tie, press the another input button or the other output button.

Front Panel Security Lockout (Executive Mode)

The front panel security lockout limits the operation of the Integration Scaling Matrix switcher from the front panel. When the switcher’s front panel is locked, all of the front panel functions are disabled except for input and output selection and black/mute selection.

To toggle the front panel lock on and off, press and hold the Color/Tint and Center buttons for approximately 2 seconds (see figure 24). The LCD displays Executive Mode Enabled or Executive Mode Disabled to indicate the mode. Release the buttons. The LCD also displays Executive Mode Enabled if you push a locked out button when the switcher’s front panel is locked.

Default

Cycle

Press and hold both buttons simultaneously for 2 seconds




	COLOR/				CENTER
	TINT
ISM 482							ISM 482
ISM 482							ISM 482
Executive Mode			OR			Executive Mode
Enabled							Disabled

10sec. timeout

Figure 24. Front Panel Security Lockout Flowchart

ISM 482 Integrated Scaling Matrix Switcher • Operation

26

Image 32

Contents ISM No Photo Available yetSafety Instructions Notifications Specifications Availability Conventions Used in this GuideFCC Class a Notice Software Commands X! *X1@* X1%* X1** X1 CEContents Switcher Software Html OperationEthernet Connection Reference InformationAbout This Guide About the SwitcherIntroduction ISM Features InputsISM 482 Integrated Scaling Matrix Switcher Introduction Installation Mounting the SwitcherTabletop Placement Rack MountingCabling and Rear Panel Views Input ConnectionsConnections for Various Input Video Formats Standard Output Connections BNC Output Connections for Rgbhv and Rgbs VideoCabling and RJ-45 connector wiring Optional Output ConnectionEthernet Connection Choosing a network cableConfiguration Wiring the network cableRS-232 Connection Pin RS-232 FunctionFront Panel Controls and Indicators OperationVideo/Audio Selection Button and LEDs Output Buttons and LEDsRecalling a user preset Input Buttons, LEDs, and Label WindowFront panel input label window Selecting an inputAuto imaging an input Picture Adjustment ButtonsBlack/Mute Button and LEDs Adjustment Knobs PowerFront Panel Operations LCD DisplayMenu System Overview Extron Electronics ISM 60-425-01 VersionVideo & Audio Configuration menu Input Configuration submenuOutput Configuration menu Output Resolution submenuSync Type and Polarity submenu Advanced Configuration Menu 000Blue-Only Mode and Edge Smoothing submenu RGB Delay submenuTest Pattern submenu Blanking submenuEnhanced Mode submenu Pixel Phase submenuPAL Film Mode submenu Reset submenuUser Presets menu Save Preset submenuErase Preset submenu Exit menuPicture Adjustments Picture Adjustments FlowchartFront Panel Security Lockout Executive Mode Front Panel Security Lockout FlowchartIP Information Flowchart IP InformationOptimizing the Video Optimizing the Audio TroubleshootingSetting up a DVD source Specific Problems General ChecksProgramming Guide RS-232 LinkDefault Address Ethernet LinkSymbols = HdtvSwitcher-Initiated Messages Power-upTies Creation Input and Output Video Type@BrtX1 RGB Delay PAL Film ModeAutomated Adjustments Test PatternUsing the Command and Response Table Host-to-Switcher InstructionsSwitcher Error Responses Command and Response Table for SIS Commands Tint BrightnessContrast Horizontal sizeCommand and Response Table for SIS Commands User presets Detail filter S-video and composite video inputsAuto Memories FreezeFront panel security lockout Executive mode Verbose modeSet audio gain and attenuation Audio muteResets Information requestsCommand and response table Command and Response Table for IP SIS CommandsSymbol definitions RGB delay Scaler output settingsEnhanced mode PAL film modeMemory backup Control Software for Windows Switcher SoftwareInstalling the Software Ethernet protocol settings Software Operation via EthernetUsing the Control Program If you selected a comm port, proceed to stepWindows Control Program Window Using the Help Program Button-Label GeneratorUsing the Software Extron Button-Label Generator WindowHtml Operation Loading the Startup ControlEnter Network Password Changing the RGB Delay ControlCreating a Tie Blacking out the Screen and Muting the AudioUsing Blue-Only Mode Executive ModeFreezing the Output Outputting a Test PatternSystem Configuration Administration FieldsISM IP Settings Fields ISM IP Address fieldISM Name field Hardware Address fieldFile Management File ManagementInput Configuration O ConfigurationOutput Resolution, Rate, Sync Format, and Polarity Output format Output resolutionOutput rate Output polarity Polarity Drop BoxMaintenance Modifications Opening and Closing the SwitcherRemoving the ISM Cover Installing a Firmware Upgrade ISM Firmware Chip LocationsInstalling a DVI Output Card DVI Output Card Connector Opening and Socket J14Output DVI Board Installation Ethernet Connection CablingPinging to Determine the Web IP Address Determining Default AddressesPinging to Determine the Switcher IP Address Open Connecting as a Telnet ClientTelnet Tips Escape character and Esc key Local echoSet carriage return-line feed CloseOptional Accessories Reference InformationPart Numbers Included PartsCables and Connectors Assorted connectorsButton Labels Bulk cablePage Extron Warranty USA, Canada, South America Central America Japan

Related manuals

Manual 105 pages 36.37 Kb