Extron electronic 300, PVS 400, 200 PCM 240 Projector Ceiling Mount, PMP Projector Mounting Pole

Stage OneStage— Ins all the Screen and Projector1

This stage involves installing the three pieces of hardware shown below.

PCM 240 Projector Ceiling Mount

1-gang and 2-gang Accessory Mounting Points (e.g. power sockets)

Pipe

PipeAdapter

Adapter

Set Screws (2)

T-bar

Securing

Screws (4)

Pipe Adapter Plate

Lock Nuts (4)

Where it goes: Attaches to structural ceiling, rests on

suspended ceiling.

What it does: Holds PMP, pole mount kit (see Stage 4), and projector.

PMP Projector Mounting Pole

	Cable
	Access
Threaded at both	Cutout
	(install this
ends
	end uppermost)

Where it goes: Screws up into PCM 240.

What it does: Holds pole mount kit and projector.

UPB 25 Universal Projector Bracket (shown separated into the two sections)

	Adjuster Plate		Projector Bracket	Projector Securing
	(Top Section)		(Bottom Section)	Screw
		Set Screws (2)	Adjuster Plate	Threaded
				Barrels (4)
Vertical Angle		Horizontal Angle	Locking Screws (4)
Adjustment		Adjustment Screws (4)
Screws (4)		Pivot Point Screws (4)
				Arm Adjustment
				Screws (4)
	Pivot			Security Flange
	Point
		Security Flange		(on rear)
	Screw
		(on rear)
			360° Movement

Where it goes: Adjuster plate screws onto base of PMP, and projector bracket attaches to projector.

What it does: Attaches projector to PMP. Allows projector orientation to be adjusted in three planes.

2-2 PoleVault Systems Installation • Installation — Stage 1