Extron electronic PVS 400, 300, 200 manual Cut ceiling tile

NThe installation must conform to national and local electrical codes, and UL requirements. Refer to the device’s user manual for details.

1.Cut ceiling tile

If installing PV SI 3C LP speakers, do the following:

a.Remove the ceiling tiles where the speakers are to be installed.

TFor ease of working on the speaker when it is replaced on the T-bar, remove an adjacent tile(s).

b.Locate the tile center, and using the supplied template, trace and cut the holes for the speakers.

TPlace an empty box under the tile for support and to collect the waste.

Measure and mark the center point of the tile and align	1b Mark the tile and cut the hole
the cross marks with those on the supplied template.

Use a fine hacksaw blade to cut the tile without damaging the face.

a.Lay two supplied speaker V-rails across the tile on either side of the hole.

b.Remove the C-ring from the speakers and attach it to the center of the V-rails with the supplied hardware.

TAt the ends of each V-rail, bend the tabs upwards. This makes it easier when replacing the tile back on the T-bars. When installation is complete, bend the V-tabs

down onto the T-bars
	2a Place the V-rails on either side of the
	hole, insert and 2b attach the C-ring

c.Remove the plenum cover from the speaker terminals

d.Insert the speaker into the ceiling tile from the face side.

Bend Tabs

Upwards

Bend the end tabs upwards.

Loosen the screws and remove the plenum cover.

2c Remove plenum cover

PoleVault Systems Installation • Installation — Stage 3 2-17