Extron electronic 200, 400 Mark screen location, 1a Mark the screen location, 2c Install the PMP

1.Mark screen location

a. Mark the center line and the outer edges of screen.

T When marking the location of screens, devices, or site for installing transmitters and MediaLink control devices, use painters tape to avoid wall surface damage.

1a Mark the screen location

When marking the center line of the screen,

where possible, keep it aligned with the center of the ceiling tile. This makes the projector installation and alignment easier.

b.Mark any structural studs, utility pipes, conduits, or fire-breaks before drilling the hardware holes. Do not drill the holes at this time.

2. Install projector to verify location PCM

a.Remove the ceiling tiles, and mark the maximum and

minimum throw distances on the T-frame.	Minimum/Maximum
b. Place the PCM 240 over the T-frame, between the two	Throw Distance Marks
marks. Lightly tighten the frame screws.

4 Place the PCM 240 on the T-bar

c.Back out the set screws on the PCM 240 adapter plate and screw the PMP into the pipe adapter, with the cable access hole closest to the ceiling. Turn it so the cable access hole faces away from the screen.

Tighten the set screws.

d.Back out the set screws on the top portion (the adjuster plate, see Abelow) of the UPB 25, and screw the plate onto the base of the PMP. Align it so the security flange is at the rear. Tighten the set screw.

PMP installed onto PCM 240

2c Install the PMP

a

Adjuster

Plate

Security flange

Set Screws (2)

Loosen the four Adjuster Plate

Locking Screws and slide the

Adjuster Plate away from the

Projector Bracket

b

Projector

Bracket

Adjuster Plate

Locking Screws (4)

2d Screw the adjuster plate onto the PMP

PoleVault Systems Installation • Installation — Stage 1 2-3