Rear Panels

Battery Module Rear Panel

REFER TO USER'S MANUAL FOR TORQUING

SPECIFICATIONS, USE COPPER CONDUCTORS ONLY.

UTILISER SEULEMENT LES CONDUCTEURS DE CUIVRE.

Power Module Rear Panel

1.Manual Bypass Switch: This switch is used in one step of putting the UPS in "MANUAL BYPASS” mode, which must be done before performing any maintenance on the UPS with the connected load supported. [See “Operation (Special Conditions)” for step-by-step instruc- tions for going into "MANUAL BYPASS."] While this switch is on "MANUAL BYPASS," connected equipment will receive filtered AC mains power, but will not receive battery power in the event of a blackout.

2.Input Terminal Block: Use these terminals to connect your UPS to the AC main power input. Unscrew and remove terminal block plate for access.

3.Output Terminal Block: Use these terminals to connect your UPS to equipment. A plate covering the terminal block must be unscrewed and removed for access.

4.External Battery Connector: Use this to connect a Tripp Lite battery module to the power module. Remove the cover for access. The power module will not start without a connection to a charged battery module. Refer to the battery module owner 's manual for connection instructions and safety warnings.

5.Exhaust Fan: This cools and ventilates the inside of the UPS.

6.AS-400 Interface Port: This female DB9 port connects your UPS to an IBM AS-400 computer interface via the AS-400 Cable includ- ed. It uses AS-400 communications to report UPS status and power conditions. Using this port, an IBM AS-400 computer can automati- cally save open files and shut down its operating system during a blackout. See “Communications” for details.

7.“Smart” RS-232 Interface Port: This female DB9 port connects your UPS to a workstation or server. It uses RS-232 communications to report UPS and power conditions. It is used with Tripp Lite software and the included RS-232 Cable to monitor and manage network power and to automatically save open files and shut down equipment during a blackout. See “Communications” for details.

8.Dry Contact Interface Port: This female DB9 port sends contact-closure signals to indicate line-fail and low-battery status. See “Communications,” for details.

9.Accessory Slot: Remove the small cover panel and use optional accessories to remotely control and monitor your UPS. Contact Tripp Lite Customer Support for more information and a list of available SNMP, network management and connectivity products.