Connections
Lamp Run Time Indication
When starting up and the total run time of the lamp is 1470 hours or more, the remaining lamp run time will be displayed for 1 minute. This warning message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.
REMAINING LAMP RUN TIME 30 hours
When the total run time of the lamp is 1500 hours or more, the following warning message, with the exact run time is displayed on the screen. (Typical lamp lifetime is 1000 hours, max. lamp lifetime is 1500 hours)
WARNING
Lamp run time is 1500 hours Operating the lamp longer than 1500 hours may damage the projector.
Please replace the lamp
<ENTER> to continue
Lamp run time is 1500 hours. Operating the lamp longer than 1500 hours may damage the projector. Please replace the lamp.
When OK (ENTER) is pressed to go on, the warning will be repeated every 30 min.
The total lifetime of the lamp for a safe operation is 1500 hours max. Do not use it longer. Always replace with a same type of lamp. Call a BARCO authorized service technician for lamp replacement.
Lamp Runtime Warning
Using a lamp for more than 1500 hours is dangerous as the lamp could explode.
Lamp Light Output Indication
When starting up and the center lumens measurement is lower than 50 % of its initial value, the lamp light output warning will be displayed. Press ENTER to continue. The message will not be repeated during operation.
WARNING
Lamp run time is 1400 hours.
The light output of the lamp is less
than 50% of its initial value.
It is advisable to replace the lamp
before damage occurs.
<ENTER> to confirm
When the 'Constant Light Ouput' (CLO) options is installed, the light output message will appear on the screen when the light output is reduced with 33% from its initial value.
This message will be repeated every hour.
Switching to Stand-by.
When the projector is running and you want to go to
Switching Off
To switch off:
-First press STANDBY key and let the projector cool down until the fans stop blowing, or at least 15 min.
-Switch off the projector with the power switch.
| R5976336 BARCOSLM R6 Executive 06092001 | |
|