Service Mode
-Projector Run Time : gives the total run time since the first start up. All projectors leave the factory with a run time of approximately 24 hours.
-Projector Serial number : indicates the fabrication number of the projector. This number can be useful when calling for technical assistance.
Change Password
How to enable or disable the password function ?
The password function is enabled when the password switch, second switch of S2, on the controller module is in the ON position.
To get access to the controller module, proceed as follows :
1Power down the projector and disconnect the power cord from the wall outlet.
2 Loosen the indicate screws of the input box (image 1).
3 Pull out the input box by both handlers.
4 When looking inside the box, the controller module with the switches is situated in the middle of the box (image 2). 5 Change the position of S2 (image 2).
Image 1
Image 2
About password Types.
3 different password levels are built in, in the projector software. The different levels are :
owner user guest
Depending on your password level some password protected items are accessible and others not.
The owner (which has the highest level) can set up via the 'Access control list' the accessibility of the different items. See 'Access Control List'.
R5976336 BARCOSLM R6 Executive 06092001 |
| |
|