Installation Mode
Defining the Infrared Communication protocol
When a peripheral is connected to the 'Comm Port', the communication can be in PPM or RC5.
The type of communication can be set to :
-PPM
-RC5
To define the communication :
1Push the cursor key or to highlight '800 Peripheral' (menu 1).
2 Press ENTER to select.
3 Push the cursor key or to highlight 'Infrared'. 4 Press ENTER to toggle between [PPM] or [RC5].
INSTALLATION
INPUT SLOTS
800PERIPHERAL CONVERGENCE
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
NO SIGNAL
LENS
QUICK ACCESS KEYS
MENU POSITION [DEFAULT]
Select with or
then <ENTER>
<EXIT> to return.
menu 1
800 PERIPHERAL
OUTPUT MODULE [STANDARD] INFRARED [PPM]
Select with or <ENTER> to toggle <EXIT> to return.
menu 2
Convergence
What can be done ?
The convergence of the displayed image can be adjusted only by a qualified service technician.
How to start up ?
1Push the cursor key or to highlight 'Convergence' (menu 1).
2 Press ENTER to select.
When Convergence is selected in the Installation Mode selection menu, the following warning will be displayed :
Convergence is reserved to qualified service personnel.
If you are not qualified, press EXIT to cancel the Convergence selection.
INSTALLATION
INPUT SLOTS
800PERIPHERAL
CONVERGENCE
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
NO SIGNAL
LENS
QUICK ACCESS KEYS
MENU POSITION [DEFAULT] Select with or
then <ENTER>
<EXIT> to return.
menu 1
WARNING
CONVERGENCE
is reserved to
qualified
service personnel
<ENTER> to accept
<EXIT> to return.
menu 2
R5976336 BARCOSLM R6 Executive 06092001 |
| |
|