Getting Started
Operating the Projector
Switching on
Use the power switch to switch on.
When '0' is visible, the projector is switched off. When '1' is visible, the projector is switched on.
When switching on with the power switch, the projector starts in the stand by mode. The projector mode indication lamp is red.
To start image projection :
a. press the 'Stand by' button A on the local keypad or on the remote control. The projector mode indication lamp will be green.
b. press a digit button to select an input source. The projector mode indication lamp will be green.
Lamp Run Time Indication
When starting up and the total run time of the lamp is 1470 hours or more, the lamp remaining run time will be displayed for 1 minute. This warning message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.
REMAINING LAMP RUN TIME 30 h
When the total run time of the lamp is 1500 hours or more, the following warning message, with the exact run time is displayed on the screen. (Typical lamp lifetime is 1000 hours, max. lamp lifetime is 1500 hours).
Lamp run time is 1500 hours. Operating the lamp longer than 1500 hours may damage the projector. Please replace the lamp.
WARNING
Lamp run time is 1500 hours Operating the lamp longer than 1500 hours may damage the projector.
Please replace the lamp
<ENTER> to continue
When OK (ENTER) is pressed to go on, the warning will be repeated every 30 min.
The total lifetime of the lamp for a safe operation is 1500 hours max. Do not use it longer. Always replace with a same type of lamp. Call a BARCO authorized service technician for lamp replacement.
Lamp Run Time Warning
Using a lamp for more than 1500 hours is dangerous as the lamp could explode.
R5976336 BARCOSLM R6 Executive 06092001 |
| |
|