Garmin EDP70 manual Display Page Headings, System Normal, RECT/BATT Alarms No Alarms Active

Page 48

10.4Display Page Headings

After initial power up, under normal operating conditions, the main page heading will be displayed:

UPS xx KVA

SYSTEM NORMAL

The first line displays the power rating of the EDP70 PLUS UPS, the second line is the system status.

During normal operating conditions, the display reading always returns to this page heading whenever the user switches are not operated for at least 5 minutes.

By pressing the button marked

once, the battery rectifier heading is displayed:

RECT/BATT ALARMS

NO ALARMS ACTIVE

The second line of the display confirms that the rectifier and battery are functioning correctly.

By pressing the button marked

again, the inverter heading is shown on the display:

INVERTER ALARMS

NO ALARMS ACTIVE

The second line of the display confirms that the inverter is functioning correctly.

By pressing the button marked

again, the load output and reserve supply heading is displayed:

LOAD/RES ALARMS

NO ALARMS ACTIVE

The second line of the display indicates that the UPS load output and reserve supply input are correct.

page 48 --MI00/10056 rev. 8 —05/2006

Image 48
Contents EDP70 Plus 2 --MI00/10056 rev -05/2006 Electrical Precautions Emergency ProcedureElectric Shock Injuries Caused by Contact with Corrosive LiquidsContents Maintenance and Spare Parts Figures Equipment Delivery and Storage 8 -- MI00/10056 rev -05/2006 Introduction 24kVA Standard Configuration 36kVA Standard Configuration36kVA 480V/208V Configuration RECTIFIER/INVERTER 24/36kVA Ratings Contactor 24/36kVA Ratings Safety Eye goggles Rubber gloves Rubber apron Rubber boots Storage ALL Measurements are Millimeters and Inches 18 --MI00/10056 rev -05/2006 Cable Entry Battery Cabinet Drawing for 24/36kVA Ratings Battery Cabinet Drawing for 24/36kVA Ratings Battery Cabinet Drawing for 50/80kVA Ratings Battery Cabinet Drawing for 50/80kVA Ratings Access Plate FuseCable EntryConnection Points40.16 32.68BTU/H Recommended wire sizes UPS Type = 2770 - - - e 0.125 h Tk / T0 T k Uninterruptible Power System No Unauthorized Operation Connection#$# % # #% + ,+% AWG M10Nest Stationary Tool Indentor MoveableS2 = Equipment Reserve Switch Observe Polarities and Orientations Front RAU FemaleRear U1V1W1N PE U V W N U2V2W2 N36 --MI00/10056 rev -05/2006 36 24/30/36kVA Connections QS1 QS4 QS2Terminal board compartment 40 --MI00/10056 rev -05/2006 QS1 QS2 QS3 QS4 QS5 RearSignal connections Emergency Power Off Controls Right Control Maintenance Bypass Installing the EPO SHUT-DOWNSilencing Audible Alarm MimicLiquid Crystal Display RECT/BATT Alarms No Alarms Active Inverter Alarms No Alarms ActiveLOAD/RES Alarms No Alarms Active Display Page HeadingsBattery Test Weekly Selected Language EnglishPower History Down to Access Load F xx.x Hz Xxx V B xxx V C Last Mains Failure xxd xxh xxm xxs Vdc xxx V Ib xxxx a Inverter F xx.x Hz Xxx V B xxx V C xxxInverter F xx.x Hz AB xxx V BC xxx V CA xxx InverterLoad Abnormal operating mode messages Main page Heading Alarms Message ConditionSystem Alarm Battery Discharging OverloadStop DUE to Overload RECTIFIER/BATTERY Alarms Message Condition Inverter Alarms Message Condition LOAD/RESERVE Alarms Message Condition Power History Power History MatrixBattery Test Battery Autonomy TestResetting data loss manually System normal message11.1 AS400 11.2 RS232 13.1 EDP70 PLUS/24/18/12 Battery Installation/Start-up SafetyEDP70 PLUS/24/18/12 Internal Battery Shelves 13.2 EDP70 PLUS/24/18/12 Optional Battery Cubicle13.3 EDP70 Plus above 24KVA Battery Installation/Start-up 13.4 EDP70 Plus above 24KVA Battery CubicleEDP70 Plus System LOG