Garmin EDP70 manual Inverter Start Up, Right Control

Page 44

6.2Control Panel

Inverter Start Up

This allows the user to turn on and reset the inverter. This is normally only used when starting the UPS.

Inverter Shutdown

The

switch incorporates a safety feature

to prevent

inadvertent

operation

yet

still

allow rapid

shutdown in the event of an emergency. This is achieved by the requirement that the switch be depressed

for

2 seconds before the inverter stops during which time the audible alarm will be heard.

 

 

Audible Alarm Cancel Switch

This switch cancels the audible alarm. When pressed the red warning light goes from continuous illumination to flashing on and off.

Page Right Control

This switch changes the page headings displayed on the LCD. It also allows the alarm and measurement

statuses to be stepped through when examining the power history (refer to section 10.6)

Record Up

This switch changes the record displayed on the LCD to the previous message displayed. When

the top of

the page has been reached the display will no longer scroll.

 

Record Down

This switch changes the record displayed on the LCD to the next record on the

page. When the bottom

of the page has been reached the display will no longer scroll.

 

page 44 --MI00/10056 rev. 8 —05/2006

Image 44
Contents EDP70 Plus 2 --MI00/10056 rev -05/2006 Electrical Precautions Emergency ProcedureElectric Shock Injuries Caused by Contact with Corrosive LiquidsContents Maintenance and Spare Parts Figures Equipment Delivery and Storage 8 -- MI00/10056 rev -05/2006 Introduction 36kVA 480V/208V Configuration 24kVA Standard Configuration36kVA Standard Configuration RECTIFIER/INVERTER 24/36kVA Ratings Contactor 24/36kVA Ratings Safety Eye goggles Rubber gloves Rubber apron Rubber boots Storage ALL Measurements are Millimeters and Inches 18 --MI00/10056 rev -05/2006 Cable Entry Battery Cabinet Drawing for 24/36kVA Ratings Battery Cabinet Drawing for 24/36kVA Ratings Battery Cabinet Drawing for 50/80kVA Ratings Battery Cabinet Drawing for 50/80kVA Ratings Access Plate FuseCable EntryConnection Points40.16 32.68BTU/H Recommended wire sizes UPS Type = 2770 - - - e 0.125 h Tk / T0 T k Uninterruptible Power System No Unauthorized Operation Connection#$# % # #% + ,+% AWG M10Nest Stationary Tool Indentor MoveableS2 = Equipment Reserve Switch Observe Polarities and Orientations Front RAU FemaleRear U1V1W1N PE U V W N U2V2W2 N36 --MI00/10056 rev -05/2006 36 24/30/36kVA Connections QS1 QS4 QS2Terminal board compartment 40 --MI00/10056 rev -05/2006 QS1 QS2 QS3 QS4 QS5 RearSignal connections Emergency Power Off Controls Right Control Maintenance Bypass Installing the EPO SHUT-DOWNLiquid Crystal Display Silencing Audible AlarmMimic RECT/BATT Alarms No Alarms Active Inverter Alarms No Alarms ActiveLOAD/RES Alarms No Alarms Active Display Page HeadingsBattery Test Weekly Selected Language EnglishPower History Down to Access Load F xx.x Hz Xxx V B xxx V C Last Mains Failure xxd xxh xxm xxs Vdc xxx V Ib xxxx a Inverter F xx.x Hz Xxx V B xxx V C xxxInverter F xx.x Hz AB xxx V BC xxx V CA xxx InverterLoad System Alarm Abnormal operating mode messagesMain page Heading Alarms Message Condition Stop DUE to Overload Battery DischargingOverload RECTIFIER/BATTERY Alarms Message Condition Inverter Alarms Message Condition LOAD/RESERVE Alarms Message Condition Power History Power History MatrixBattery Test Battery Autonomy TestResetting data loss manually System normal message11.1 AS400 11.2 RS232 13.1 EDP70 PLUS/24/18/12 Battery Installation/Start-up SafetyEDP70 PLUS/24/18/12 Internal Battery Shelves 13.2 EDP70 PLUS/24/18/12 Optional Battery Cubicle13.3 EDP70 Plus above 24KVA Battery Installation/Start-up 13.4 EDP70 Plus above 24KVA Battery CubicleEDP70 Plus System LOG