STACK menu settings
3.5 Selecting input source for Sub
1.Highlight SUB INPUT SOURCE in the STACK menu with the ▲/▼ buttons, then press the ► button to display the SUB INPUT SOURCE dialog.
2.Use the ▲/▼ buttons in the dialog to highlight FOLLOW MAIN UNIT or FIXED (COMPUTER IN 1).
FOLLOW MAIN UNIT: Sets the input source on the Sub projector to the same port as Main.
FIXED (COMPUTER IN 1): Sets the input source on the Sub projector to the COMPUTER IN1 port which is connected to the MONITOR OUT port on the Main projector.
3.Press the ◄ button to return to the previous menu, or press the ► button to save the setting. (19)
NOTE • <Only for IN5135 and IN5145> When the projectors are in the PbyP mode, the SUB INPUT SOURCE is set to FOLLOW MAIN UNIT.
•If FIXED (COMPUTER IN 1) is selected, either the COMPUTER IN1 or IN2 port can be selected as an input source on the Main projector. When any source button on the remote control or the INPUT button on the projector is pressed, the MAIN INPUT SOURCE dialog will be displayed on screen. Select COMPUTER IN 1 or COMPUTER IN 2 with the ▲/▼ buttons.
•If FIXED (COMPUTER IN 1) is selected, the COMPUTER IN1 port on the Sub projector should be connected to the MONITOR OUT port on the Main projector with a computer cable. The image from the selected port is output from the MONITOR OUT port on the Main projector to the COMPUTER IN1 port on the Sub projector. The MONITOR OUT setting on the Main projector is disabled when FIXED (COMPUTER IN 1) is selected. (Operating Guide → SETUP menu)
•If FIXED (COMPUTER IN 1) is selected, video signals can be input to the COMPUTER IN1 or IN2 port on the Main projector. Set the port for video signal input in the COMPUTER IN menu and set the video format in the VIDEO FORMAT menu. Refer to Inputting image from Main to Sub (24) and Inputting image from Main to Sub - Video signal (either component or video). (28)
18