InFocus IN5132 Installing the second projector Set B, Connecting projectors, Setting up Set B

Installation

2.3 Installing the second projector (Set B)

Deciding the installation position

Decide the position of Set B and its projection angle. (User’s Manual (concise)

→Arrangement and Adjusting the projector’s elevator)

WARNING ►For IN5142, IN5144, IN5144a and IN5145 only: You can install the projector in any direction with specified mounting accessories. Consult with your dealer for that type of installation.

NOTE • Set the tilt angle of Set B within 9 degrees of the level line.

Connecting projectors

To use Intelligent Stack, connect an RS-232 null modem cable between the CONTROL port of Set A and Set B.

Setting up Set B

1.Turn on Set B.

NOTE • After turning on Set B, verify the image of Set B is not significantly tilted compared to the image of Set A. If the image is overly tilted, rotate the elevator feet of Set B to adjust the angle so that the tilt is just about right.

2.Reset the adjustment of KEYSTONE and PERFECT FIT on Set B.

(Operating Guide → EASY MENU or SETUP menu)

NOTE • KEYSTONE cannot be selected when PERFECT FIT is in use. To reset both functions, reset PERFECT FIT first.

•Set up the INSTALLATION settings first because the image position may change. (Operating Guide → SETUP menu)

(continued on next page)

8