InFocus IN5144A, IN5132, IN5134A, IN5135, IN5142, IN5145 Stack menu settings, Displaying Stack menu

Page 13

3. STACK menu settings

Set up Intelligent Stack settings in the STACK menu.

NOTE • If you are using Simple Stack without an RS-232 connection, skip this chapter.

•If you do not need to change the settings made during the installation process described in the previous chapter, go to 3.3 Selecting lamp operation mode. (15)

•Read 3.7 Important information for Intelligent Stack carefully. (20)

3.1 Displaying STACK menu

Use the ▲/▼/◄/► buttons to go into the fol- lowing menu.

ADVANCED MENU > OPTION

>SERVICE > COMMUNICATION > STACK

STACK menu will appear on screen. (Operating Guide → OPTION menu) The setting for Intelligent Stack operation starts from this menu.

NOTE • Check that the following settings are made on both projectors. Otherwise, the STACK menu on the projectors cannot be selected. (5)

-STANDBY MODE in SETUP menu: NORMAL (Operating Guide → SETUP menu)

-COMMUNICATION TYPE under COMMUNICATION in SERVICE menu: OFF (Operating Guide → OPTION menu)

-STACK LOCK in SECURITY menu: OFF (5)

13

Image 13

Contents IN5132/IN5142/IN5134/IN5134a IN5144/IN5144a/IN5135/IN5145 FeaturesContents Introduction Remote control for Intelligent Stack and Simple StackBasic information and preparations Instant StackIntroduction Preparing for Intelligent Stack InstallationDeciding the installation position Installing the first projector Set aSetting up Set a Advanced Menu Option Service Communication Stack Connecting projectors Installing the second projector Set BSetting up Set B Installation Confirming Main and Sub settings For Intelligent Stack users Fine adjusting image positionFor Simple Stack users Displaying Stack menu Stack menu settingsSelecting Main, Sub or off Only for IN5142, IN5144, IN5144a and IN5145 Selecting lamp operation modeSelecting lamp operation mode Selecting lamp switching mode Selecting input source for Sub Stack menu Exiting Intelligent Stack menuDialog from Stack menu Important information for Intelligent Stack USB Type A, USB Type B, LAN Example ServiceConnecting an RS-232 cable Connecting cablesInputting the image from Main to Sub Connecting signal cablesComputer IN1 and IN2 Inputting the image to Sub and Main individuallyPreparing for menu operations Setting input ports using menuChecking Main projectors operating status Starting up Main projector Inputting image from Main to Sub Computer signal Setting the menuInputting image to Sub and Main individually Setting input ports using menu Restrictions on the Main projector Restrictions on Schedule functionRestrictions on the Sub projector Restrictions on Schedule function Troubleshooting Two images are adjusted differently Remote control is pointed at the SubProjector Two images are not superimposed

Related manuals

Manual 167 pages 23.25 Kb