InFocus IN5134A, IN5132, IN5135 Setting input ports using menu, Preparing for menu operations

Page 25

5.Setting input ports using menu

5.1Preparing for menu operations

If Simple Stack without an RS-232 connection is used, press the related source button on the remote control or press the projector's INPUT button to select the port which has the connected cable. For setting up MONITOR OUT, refer to SETUP menu in Operating Guide.

This completes set up.

If Intelligent Stack with the RS-232 connection is used, all settings or modifications related to Intelligent Stack menu operations must be completed using the Main projector. The Main projector functions according to the Intelligent Stack settings

5.2 Checking Main projector's operating status

For Intelligent Stack, all settings or modifications related to menu operations must be completed using the Main projector. Before operating the menu for Intelligent Stack, check if the Main projector is functioning.

1.Press the MENU button on the remote control.

2.If the MENU dialog as shown on the right appears on the screen, the two projectors are operating in DUAL mode and the Main projector is operating.

Go to 5.4 Setting the menu. (27)

If the dialog does not appear, LAMP MODE is set to ALTERNATE and either the Main or Sub projector is operating. Go to next.

3.Use the ▲/▼/◄/► buttons to go into the following menu.

ADVANCED MENU > OPTION

>SERVICE > COMMUNICATION

>STACK

STACK menu will appear on screen.

(Operating Guide → OPTION menu)

4.Check the STACK MODE setting in the STACK menu.

-If MAIN is displayed, the Main projector is operating. Go to 5.4 Setting the menu. (27)

-If SUB is displayed, the Main projector is turned off and the Sub projector is operating. Go to 5.3 Starting up Main projector. (26)

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents IN5132/IN5142/IN5134/IN5134a IN5144/IN5144a/IN5135/IN5145 FeaturesContents Introduction Remote control for Intelligent Stack and Simple StackBasic information and preparations Instant StackIntroduction Preparing for Intelligent Stack InstallationDeciding the installation position Installing the first projector Set aSetting up Set a Advanced Menu Option Service Communication Stack Connecting projectors Installing the second projector Set BSetting up Set B Installation Confirming Main and Sub settings For Intelligent Stack users Fine adjusting image positionFor Simple Stack users Displaying Stack menu Stack menu settingsSelecting Main, Sub or off Only for IN5142, IN5144, IN5144a and IN5145 Selecting lamp operation modeSelecting lamp operation mode Selecting lamp switching mode Selecting input source for Sub Stack menu Exiting Intelligent Stack menuDialog from Stack menu Important information for Intelligent Stack USB Type A, USB Type B, LAN Example ServiceConnecting an RS-232 cable Connecting cablesInputting the image from Main to Sub Connecting signal cablesComputer IN1 and IN2 Inputting the image to Sub and Main individuallyPreparing for menu operations Setting input ports using menuChecking Main projectors operating status Starting up Main projector Inputting image from Main to Sub Computer signal Setting the menuInputting image to Sub and Main individually Setting input ports using menu Restrictions on the Main projector Restrictions on Schedule functionRestrictions on the Sub projector Restrictions on Schedule function Troubleshooting Two images are adjusted differently Remote control is pointed at the SubProjector Two images are not superimposed
Related manuals
Manual 167 pages 23.25 Kb
Top Page Image Contents