InFocus IN5135, IN5132, IN5134A Setting the menu, Inputting image from Main to Sub Computer signal

Page 27

Setting input ports using menu

5.4 Setting the menu

If Intelligent Stack with RS-232 connection is used, observe the following. When inputting image signals to Sub via Main, the operations differ between using computer signals and video signals such as component and video signals.

Inputting image from Main to Sub - Computer signal

1.If the STACK menu is already displayed on the screen, proceed to 3 below. Otherwise press the MENU button on the remote control.

If the MENU dialog is displayed, use the ▲/▼ buttons to highlight MAIN, and press the ► button. A menu will be displayed.

If the MENU dialog is not displayed, the STACK menu will appear.

2.Use the ▲/▼/◄/► buttons to go into the following menu.

ADVANCED MENU > OPTION

>SERVICE > COMMUNICATION > STACK

STACK menu will appear on screen.

(Operating Guide → OPTION menu)

3.Use the ▲/▼ buttons to highlight SUB INPUT SOURCE, and press the ► button to display the SUB INPUT SOURCE dialog.

4.Use the ▲/▼ buttons to highlight FIXED (COMPUTER IN 1), and press the ► button to save the setting. (19)

5.Press any source button on the remote control or the INPUT button of the Main projector. The MAIN INPUT SOURCE dialog is displayed on screen. Use the ▲/▼ buttons to highlight the port to which the signal cable is

connected, and press the ► button to save the setting.

NOTE • When FIXED (COMPUTER IN 1) is selected, the MONITOR OUT setting is invalid. (Operating Guide → SETUP menu)

•When FIXED (COMPUTER IN 1) is selected, you cannot select any input sources besides COMPUTER IN1 and COMPUTER IN2.

•When FIXED (COMPUTER IN 1) is selected and any source button on the remote control or the INPUT button on the Main projector is pressed, the dialog for selecting the input source will be displayed.

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents IN5132/IN5142/IN5134/IN5134a IN5144/IN5144a/IN5135/IN5145 FeaturesContents Instant Stack Remote control for Intelligent Stack and Simple StackIntroduction Basic information and preparationsIntroduction Preparing for Intelligent Stack InstallationInstalling the first projector Set a Deciding the installation positionSetting up Set a Advanced Menu Option Service Communication Stack Installing the second projector Set B Connecting projectorsSetting up Set B Installation Confirming Main and Sub settings For Intelligent Stack users Fine adjusting image positionFor Simple Stack users Displaying Stack menu Stack menu settingsSelecting Main, Sub or off Only for IN5142, IN5144, IN5144a and IN5145 Selecting lamp operation modeSelecting lamp operation mode Selecting lamp switching mode Selecting input source for Sub Exiting Intelligent Stack menu Stack menuDialog from Stack menu Important information for Intelligent Stack USB Type A, USB Type B, LAN Example ServiceConnecting an RS-232 cable Connecting cablesInputting the image to Sub and Main individually Connecting signal cablesInputting the image from Main to Sub Computer IN1 and IN2Setting input ports using menu Preparing for menu operationsChecking Main projectors operating status Starting up Main projector Inputting image from Main to Sub Computer signal Setting the menuInputting image to Sub and Main individually Setting input ports using menu Restrictions on Schedule function Restrictions on the Main projectorRestrictions on the Sub projector Restrictions on Schedule function Troubleshooting Two images are not superimposed Remote control is pointed at the SubTwo images are adjusted differently Projector
Related manuals
Manual 167 pages 23.25 Kb
Top Page Image Contents