Restrictions on Schedule function

6. Restrictions on Schedule function (continued)

are operating in Intelligent Stack. If the input port can be used in Intelligent Stack, then it can also be scheduled and executed. If not, it will not be executed.

X *2): This can be scheduled using Projector Web Control when the projectors are operating in Intelligent Stack but it will not be executed.

X *3): This cannot be scheduled or executed using Projector Web Control when the projectors are operating in Intelligent Stack.

NOTE • If the Schedule is not executed, an error message will be sent in accordance with the conditions set in the Schedule Execution Error menu of the Projector Web Control. (Network Guide → 3.1.6 Alert Settings)

•If the Schedule function is set to turn off the power when the projectors are operating in Intelligent Stack, both the Main and Sub projectors will be turned off.

•If the Schedule function on the Main projector is set to turn on the power, the projectors will be turned on according to the LAMP MODE setting.

•When the two projectors are operating in DUAL mode and a menu is being displayed on one of the projectors, the Schedule function for My Image and Messenger on the other projector will not be executed.

•Power Off in the table refers to turning off the power and entering the standby mode according to the Intelligent Stack settings or by pressing the STANDBY button on the remote control or the Main projector's STANDBY/ON button.

•The projectors cannot be turned on by the Schedule function on the Sub projector. Scheduling power on times must be set up on the Main projector if needed.

•When the Sub projector is turned off according to the ALTERNATE MODE setting, the Schedule function on the Sub projector to turn off its power will be executed without error.