Setting input ports using menu
5.3 Starting up Main projector
After completing section 5.2 Checking Main projector's operating status, the two projectors should be set to ALTERNATE mode and the Sub projector should be operating. Because the settings for Intelligent Stack can only be changed when the Main projector is operating, this section explains how to switch from the Sub projector to the Main projector.
1.Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
>SERVICE > COMMUNICATION > STACK
The STACK menu will appear on screen. (Operating Guide → OPTION menu)
2.Check the ALTERNATE MODE setting in the menu.
If NORMAL is displayed, the two projectors are turned on alternately. Therefore, the Main projector will be turned on if you restart the projectors.
(1)Press the STANDBY button on the remote control or STANDBY/ON button of the Main projector. The Sub projector will turn off.
(2)After the projector has cooled down, press the ON or STANDBY/ON button to turn a projector on again. The Main projector will be turn on.
If AUTO is displayed, the projector with the least lamp usage will be turned on. Therefore, the Main projector may not turn on even if you restart the projectors. Follow the procedures below to turn on the Main projector.
(1)Use the ▲/▼ button to highlight STACK MODE, and press the ► button to display the STACK MODE dialog.
(2)Use the ▲/▼ button to highlight OFF, and then press the ► button to save the setting. (19)
(3)Repeat the above procedures to display the STACK MODE dialog again.
(4)Use the ▲/▼ button to highlight SUB, and then press the ► button to save the setting. (19)
(5)After exiting the menu, wait for 10 seconds or more.
(6)Press the STANDBY button on the remote control or STANDBY/ON button of the Main projector. The Sub projector will turn off.
(7)After the projector has cooled down, press the ON or STANDBY/ON button to turn a projector on again. The Main projector will be turned on even if LAMP MODE has been set to AUTO.
3.Now you can change the settings for Intelligent Stack because the Main pro- jector is operating. Go to 5.4 Setting the menu. (27)
NOTE • If the Main projector cannot be turned on due to an error or other problem, the Sub projector will be turned on even if you follow the procedures above. Take necessary actions to fix the Main projector, and then change the settings for Intelligent Stack.
26