InFocus IN5132, IN5134A, IN5135, IN5144A, IN5142 Important information for Intelligent Stack

Page 20

STACK menu settings

3.7 Important information for Intelligent Stack

This section provides important information related to setting up the Main and Sub projectors. It does not contain explanations on menu operation. Read all information carefully.

●To use Intelligent Stack, one projector must be set to Main and the other set to Sub.

●All buttons are disabled, except the STANDBY/ON button on the Sub projector's control panel. Operate the projectors with the control panel of the Main projector or the remote control.

●Pressing the STANDBY/ON button of the Sub projector does not allow you to turn off the Sub projector by itself. The Main and Sub projectors turn off when the button is pressed for more than 3 seconds. Pressing the button again will not turn on the Main or Sub projector.

●The remote control should be pointed at the Main projector because the Main projector is capable of receiving remote control signals and the Sub projector is not.

●<Only for IN5142, IN5144, IN5144a and IN5145>

Each Status Monitor can also be operated individually from the respective control panel of the Main and Sub projectors. Only the monitor on the projector that has been turned on can be operated with the remote control.

●If a wired remote control is used, connect the cable to the Main projector instead of the Sub projector.

●For simple PC mouse & keyboard functions, connect both the Main and Sub projectors to your computer with USB cables. (Operating Guide → Using as a simple PC mouse & keyboard)

●The AUTO SEARCH function is disabled when the projector is used in Intelligent Stack.

●The Sub projector cannot be turned on using network communication and Web Control to the Sub projector. The Sub projector can only be controlled through the Main projector.

●The Web Remote Control function of the Sub projector is disabled. (Network Guide → 3.1.11 Remote Control)

●If you try to turn on the projectors using the POWER ON & DISPLAY ON feature of the MESSENGER function, the projectors will exit Intelligent Stack and display the specified message. To start Intelligent Stack again, re-select MAIN/

(continued on next page)

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Features IN5132/IN5142/IN5134/IN5134a IN5144/IN5144a/IN5135/IN5145Contents Remote control for Intelligent Stack and Simple Stack IntroductionBasic information and preparations Instant StackIntroduction Installation Preparing for Intelligent StackSetting up Set a Installing the first projector Set aDeciding the installation position Advanced Menu Option Service Communication Stack Setting up Set B Installing the second projector Set BConnecting projectors Installation Confirming Main and Sub settings Fine adjusting image position For Intelligent Stack usersFor Simple Stack users Stack menu settings Displaying Stack menuSelecting Main, Sub or off Selecting lamp operation mode Only for IN5142, IN5144, IN5144a and IN5145Selecting lamp operation mode Selecting lamp switching mode Selecting input source for Sub Dialog from Stack menu Exiting Intelligent Stack menuStack menu Important information for Intelligent Stack USB Type A, USB Type B, LAN Service ExampleConnecting cables Connecting an RS-232 cableConnecting signal cables Inputting the image from Main to SubComputer IN1 and IN2 Inputting the image to Sub and Main individuallyChecking Main projectors operating status Setting input ports using menuPreparing for menu operations Starting up Main projector Setting the menu Inputting image from Main to Sub Computer signalInputting image to Sub and Main individually Setting input ports using menu Restrictions on the Sub projector Restrictions on Schedule functionRestrictions on the Main projector Restrictions on Schedule function Troubleshooting Remote control is pointed at the Sub Two images are adjusted differentlyProjector Two images are not superimposed
Related manuals
Manual 167 pages 23.25 Kb
Top Page Image Contents