InFocus IN5134A Remote control is pointed at the Sub, Projector, Two images are not superimposed

Page 33
Troubleshooting tips
The projectors are not set up for the Intelligent Stack feature.

Troubleshooting

7. Troubleshooting (continued)

Situation

Reference

page

 

Check the following settings on the Main and

 

The STACK

Sub projectors.

 

- STANDBY MODE in SETUP menu:

5

menu is not

NORMAL

functioning.

 

- COMMUNICATION TYPE under

 

 

 

 

COMMUNICATION in SERVICE menu:

 

 

OFF

 

 

- STACK LOCK in SECURITY menu: OFF

 

 

The remote control is pointed at the Sub

 

The projector

projector.

 

does not respond When operating in Intelligent Stack, only the

3

to the remote

Main projector is capable of receiving remote

 

control.

control signals. Therefore, point the remote at

 

 

the Main projector.

 

 

The two images are not superimposed

6

The images are

correctly.

 

either out of

Use the ZOOM, FOCUS and LENS SHIFT

 

focus or not well- features to fine tune the superimposed

 

superimposed.

images. If needed, adjust PERFECT FIT and

11

 

KEYSTONE as well.

 

 

The two images are adjusted differently.

 

The images

Try these steps:

 

 

 

from the two

- Press the AUTO button on the remote

49

projectors do

control or execute AUTO ADJUST

in Operating

not superimpose

EXECUTE on each of the projectors.

Guide

properly even

- Adjust H POSITION and V POSITION on

48

after finely

each of the projectors.

in Operating

adjusting the

- Check the RESOLUTION setting in the

Guide

image.

INPUT menu, and change the setting to

53

 

match if the setting differs between Main

in Operating

 

and Sub.

Guide

If you require more information on Instant Stack, please consult your dealer.

33

Image 33
Contents IN5132/IN5142/IN5134/IN5134a IN5144/IN5144a/IN5135/IN5145 FeaturesContents Introduction Remote control for Intelligent Stack and Simple StackBasic information and preparations Instant StackIntroduction Preparing for Intelligent Stack InstallationInstalling the first projector Set a Deciding the installation positionSetting up Set a Advanced Menu Option Service Communication Stack Installing the second projector Set B Connecting projectorsSetting up Set B Installation Confirming Main and Sub settings For Intelligent Stack users Fine adjusting image positionFor Simple Stack users Displaying Stack menu Stack menu settingsSelecting Main, Sub or off Only for IN5142, IN5144, IN5144a and IN5145 Selecting lamp operation modeSelecting lamp operation mode Selecting lamp switching mode Selecting input source for Sub Exiting Intelligent Stack menu Stack menuDialog from Stack menu Important information for Intelligent Stack USB Type A, USB Type B, LAN Example ServiceConnecting an RS-232 cable Connecting cablesInputting the image from Main to Sub Connecting signal cablesComputer IN1 and IN2 Inputting the image to Sub and Main individuallySetting input ports using menu Preparing for menu operationsChecking Main projectors operating status Starting up Main projector Inputting image from Main to Sub Computer signal Setting the menuInputting image to Sub and Main individually Setting input ports using menu Restrictions on Schedule function Restrictions on the Main projectorRestrictions on the Sub projector Restrictions on Schedule function Troubleshooting Two images are adjusted differently Remote control is pointed at the SubProjector Two images are not superimposed
Related manuals
Manual 167 pages 23.25 Kb