SUPER MICRO Computer I2DMR-8G2 Quick Reference i2DMR-8G2/i2DMR-iG2, Connector Description

Chapter 1: Introduction

Quick Reference (i2DMR-8G2/i2DMR-iG2)

(*Please refer to Chapter 2 for pin definitions and detailed information.)

Jumper	Description		Default Setting
CN1, CN3	SCSI Cha.A(CN3)/Cha.B(CN1)Termination (*Note4)
			Open (Enabled)
J7	GLAN Enable/Disable		Pins 1-2 (Enabled)
J31	Watch Dog		Pins 1-2 (Reset)
JBT1	CMOS Clear		(*Note 4)
JA1	SCSI Enable/Disable (*Note5)		Pins 1-2 (Enabled)
JV1	VGA Enable/Disable		Pins 1-2 (Enabled)
Connector		Description
Alarm Reset (CN5)		Fail Alarm Reset Switch
BIOS#1-6 (S1-6)		BIOS#1-6
Chassis Intrusion (J25)		Chassis Intrusion Header
COM1 (J5), COM2 (J38)COM1 & COM2 Serial Port and Header
CPU1(J30), CPU2 (J29)		CPU 1/2 Sockets
DIMM#1-#8 (J9-J16)		Memory (RAM) Slots:DIMM1(J16),DIMM2 (J13),
		DIMM3 (J11), DIMM4(J9), DIMM5 (J15),
		DIMM6 (J14), DIMM7 (J12), DIMM8 (J10)(*Note 2)
Fan Headers (1-8)		Fan1-Fan8 Headers.
Front Panel CTRL (U66)Front Control Panel Connector (*Note 3)
IDE1 (J37), IDE2 (J35)		IDE1/2 Hard Disk Drive Connectors
IPMI (J26)		IPMI 1.5, 2.0 Connector
ITP (J34)		ITP Connector (For Testing Only)
PCI-X (J19)		PCI-X Bus 256-Pin Slot
PWR1(J20), PWR2(J36) Power1 and Power2 24-Pin-Connectors
PWR Fault (U62)		Power Fault Connector
Speaker (CN4)		Speaker Connector(*Note3)
SMB (J22)		System Management Bus Connector
SMB_Power (J27)		System Management Bus Power Header
SCSI A&B (J18,J3)		SCSI A Connector(J18), SCSI B Connector(J3)
		(*Note 4)
USB 0/1(J1),USB2/3(J4)Back Panel Universal Serial Ports
USB4/5 (J21)		Front Panel USB Headers
VGA Connector (J2)		VGA Connector
WOR (J6)		Wake-on-Ring Header

(*Notes: 1. For 1U servers, use Fan1&Fan2 for CPU cooling. For 2U servers, use Fan1, Fan2, Fan3, Fan4 for CPU cooling.

2.See Chapter 2 for Memory Installation Instructions.

3.See Chapter 2 for detailed information.

4.For i2DMR-8G2 only)

1-5