SUPER MICRO Computer I2DMR-8G2 user manual

Chapter 5: Software Installation

After the BIOS Image file is loaded, the following screen will appear:

10.When asked "Reset NVRAM to default value? (y/n), type "y" at the

prompt, if you want to reset all default values after flashing the BIOS.(*y: This will reset your NVRAM which typically resets your boot options in EFI to manufacturer defaults. If you previously added options to boot from CDROM or Windows, these will disappear after NVRAM is reset, and in this case

you will have to re-add the options. n: This will leave NVRAM alone, thus, your boot options will still remain the same as before BIOS flashed.) Type "n" at the prompt if you want to keep the default values after BIOS flashing as shown in the screen above.

11.When asked "Proceed with flash update? (y/n), type "y" at the prompt to update the BIOS. Type "n" at the prompt if you do not want to update the BIOS. If you type "y", the system will automatically update the BIOS file.

12.After BIOS is updated, you will be asked "Reset CMOS to default values (will be done during the next boot?) y/n? as shown in the screen below. (*y: if you want to reset BIOS to manufacturer’s default settings during the next boot, or n: if you only want to update BIOS without resetting it to manufacturer’s default settings.)

(*Please note that this reset will not affect EFI boot options.)

13.Then, you will be asked "Reset the system? y/n? Type "y" at the prompt if you want to automatically reboot the system.

5-5