SUPER MICRO Computer I2DMR-8G2 Installing the Heatsink on the CPU*for CPU w/o Heatsink only

SUPER i2DMR-8G2/i2DMR-iG2 User's Manual

F. Installing the Heatsink on the CPU(*for CPU w/o Heatsink only)

(*Warning: Do not apply any thermal grease to the heatsink-the required amount of thermal grease has already been applied.)

(*Note: To maximizing the cooling effect of the i2DMR-8G2/iG2, we strongly recommend that Supermicro's proprietary heatsinks (SNK-046) be used with the Itanium 2 CPUs.)

1.Place the heatsink (P/N SKT-0046) on top of the CPU so that the four mounting holes are aligned with those on the retention mechanism as shown in Figure 1 below.

2.Screw in two diagonal screws (ie the #1 and #2 screws) until just snug (do not fully tighten), then do the same with the remaining diagonal screws as shown in Figure 2 and Figure 3.

Figure 1

1) Locate the four mounting holes on

the heatsink retention module.

Figure 2 Figure 3

2-8